Series X Plus 8 Keg Kegerator - Installation Video

The worlds most compact 8 keg kegerator is here. This video will show you how to set it up so you can be dispensing 8 kegs in no time!

[robbdenney]

Just set up the 4-tap Series X this weekend. Awesome product!

Some quick tips:

1. For the 4-tap tower with the inside screws, instead of the drill extension and masking tape method shown in the video, this is much simpler & easier: hold the tower in the air, insert the four screws in the holes with your other hand, hover the tower about 1 inch above the kegerator, align the screws into the holes (there is just enough dead space for each screw to drop in and hold in place), VERY gently lower the tower leaving all 4 screws in place, VERY carefully tighten each screw down enough to hold in place while you tighten down the rest.

2. The screws on bottom for the caster wheels where ridiculously tight on my unit and shattered my drill bit. So have a socket wrench on hand (luckily they are hex screws).

3. I stole this tip from another video - gently press and twist the tower cap onto the thin plastic packing foam to make a perfectly fitting foam insulation circle for the top of the tower.

4. Use a keg with appropriate cleaning solution (or just warm water) to clean out the lines first and test for leaks (so that warm water or cleaning solution spray all over instead of beer). I was very carful and still had 1 tap that didn't tighten in correctly.

Thats's all. Great product! KegLand continues to lead the way in new product innovation and reasonable prices.

[PortlyGentleman]

Awesome video I am eagerly awaiting the upright refrigerator you teased a few months ago ! Hopefully that one will make it to the states?

[clintwatson]

I got the 8 keg but can't fit them all in i need to see the layout please its like a tin of sardines with 2 extra sardines. If it was bigger say 50-100mm would be better

[davewebb]

Thank you for the video. The instructions are very helpful and simple. Just a quick question: I did several gas leakage checks leaving the system for several hours. Each time the high pressure gauge showed zero while the low pressure one was ok. Any advice is appreciated

[peetei]

Hey I'm super excited for this product, just wondering if there going to a a soccer goal/ bridge style modular font pack or kit that fits and hopefully with four ss nuka taps?

[ryanc]

liking this fridge to run 4 kegs plus have capacity for cans etc (with the wire rack accessory) but hate the look of 1 single offset font... wondering about a centralised hole....

[thomaskelly]

Is there no insulation on the 4 tap version

[brettmeekings]

Hi

I was wondering if you could me out? I have a Kegerator with a Birra Moretti 30L Keg chilled to 3 Degrees Celsius with a 60/40 mixed gas, my beer line from keg to tap is 2 meters in length which is also cooled. I am just wondering pressure I should set my regulator too? Feedback would be greatly appreciated.

[MrBellda]

100%, you need 3 or 4 ports at the rear of this unit... 🙂

[zappaland]

Hi! Is on line a video on how to sanitize Fermzilla? Tnx

[dylanparry]

Will two 58l kegland kegmenters fit in this ?

[Greta-Thunberg-How-Dare-You]

that was not me who thumbed down your video either, Mr Slug also has trolls on his channel

[universeofmaltedbeers]

hello I just bought the x plus series, and it is impossible to put 8 was soda in it... I am disappointed with this false information.