Sand Filter Valve Gasket Replacement Hayward SP0714T1 & SP071620T

preview_player
Показать описание
I replaced the spider gaskets in 2 different Hayward valves. I will show you the steps. You can go 2 different routes on the smaller valve. Replace the gasket and buy glue or buy the gasket already installed on the plastic valve. The bigger valve, you will have to replace the gasket.

SP0714T1 Gasket:

SP071620T or SP071621 Gasket:

Adhesive 5oz tube:

⚠ DISCLAIMER: WHILE FIX THEM THINGS STRIVES TO MAKE THE INFORMATION PROVIDED IN THIS VIDEO AS ACCURATE AS POSSIBLE, IT MAKES NO CLAIMS, PROMISES OR GUARANTEES ABOUT THE ACCURACY, COMPLETENESS OR APPLICABILITY OF THE CONTENT. NO INFORMATION CONTAINED IN THIS VIDEO SHALL CREATE ANY EXPRESSED OR IMPLIED WARRANTY OR GUARANTEE OF ANY PARTICULAR RESULT. ALL DO-IT-YOURSELF PROJECTS ENTAIL SOME RISK. IT IS THE SOLE RESPONSIBILITY OF THE VIEWER TO ASSUME THIS RISK. FIX THEM THINGS IS NOT RESPONSIBLE OR LIABLE FOR ANY LOSS DAMAGE (INCLUDING BUT NOT LIMITED TO, ACTUAL, CONSEQUENTIAL OR PUNITIVE), LIABILITY, CLAIM, OR ANY OTHER INJURY OR CAUSE RELATED TO OR RESULTING FROM ANY INFORMATION POSTED IN THIS VIDEO.
Рекомендации по теме
Комментарии
Автор

Finally had the to waste blow out. Hey, 15 years, few hard freezes. The gasket is basically plumber's putty at this point. They say 410 Loctite but those bottles fun like 30. I will use the $9 version. 401 but not loctite 401. Good tip about winterize position.

Jack-Surreal_Panes
Автор

Great video, thank you. Is there an o-ring for the top of the standpipe where it connects to the Hayward Sp0714? Or does the standpipe just slide into the valve?

pcascio
Автор

Thank you for making this. Very helpful

mikekurtz
Автор

I absolutlyvare unable to relove the spider gasket, despite using a hairdryer and a little bit of alcohol.
I already purchased the top handle spring and stem assembly, and a new spider gasket and adhesive for my old SPX0710X32 that had leaking water from the waste line. Now I, cannot proceed as my gasket is very strongly glued down. Hair dyer, and scraping ineffective. What to do?

oldrmike
Автор

I was nervous, watching inyopools videos they say the one with gasket attatached to top multiport valve(1st one you done in this video)is not replacable.I done ordered gasket and its warm so alge is growing rapidly..Your video let me know it IS possible to replace those type gaskets as well...

dameronlyon
Автор

Not sure on the first valve you did, but the second one you applied waaay too much glue. The glue on this one is supposed to be applied "sparingly"... A dot at just the outer intersections.

jhambor
Автор

Will a bad gasket cause loss of prime? I unfortunately was switching between modes while the pump was running a few times and now i keep losing prime.

JoeJumps