How to Instal Multifix Tool on Mini Lathe

her is the link about multifix

check out the lathe here

There is more to watch here:

[GenePavlovsky]

3:43 This toolholder with a V-groove is for round tools such as boring bars, the other toolholders are for regular tools with a square shank. 8:09 This is not the way to do it. You should mount a toolholder into the toolpost, set the pointer on the toolpost to the 0 position, then square the toolholder up with the chuck jaws, or zero it in with a dial indicator. This is the 0 position, regular turning tool at right angle to the workpiece. Once aligned, you tighten the toolpost nut, and you don't touch that nut again. With the toolholder out of the toolpost, you can freely rotate the toolpost's outer shell around the inner toothed center block. You get 40 different positions (spaced by 9 degrees) this way. To prevent the inner toothed block slipping under heavy loads, it can be pinned to the topslide, this is what these holes at the bottom are.

[Levisgil]

Hello,
Are you somtimes missing having a bigger spindle bore for you work? Like 38mm
Thanks for your video

[johnkinnane]

G'day and greetings from Tasmania Australia 🇦🇺 that was a very good review I have the same one which retailed at $580.00 thank you for showing how to install and use it. Regards John

[williamchua]

The 1st one is for boring bar in English. and the L-shape tool is called allen key

[spyroskatsaros]

Hello my friend, congratulations for the nice videos, my name is Spyros, I am from Greece and I live in London. Where are you from? I wish you well and make nice videos!!!👍

[jFloRED]

I would’ve turned down the male part instead of a part that would be just “a little” more difficult to reCreate 😂. Lucky for you it went smoothly.

[greppurtorfason]

Don't cut the Multifix! Make a new bolt! Oh, my.

[WaschyNumber]

They don't have any lathe on ther web side 🤔