Fun With Sik Telemetry Radio Firmware

I think I have it all figured out enough where I need wide open spaces now to continue on.

It is not in the video but while I was rendering uploading this video I did flash the Second CUAV GCS radio with Sik 2.1. No I have one pair with original firmware on them, and the second pair with Sik 2.1 firmware on them. Ready for testing!

[TimothyEventbuzz]

Hi I'm getting the message "Failed to enter command mode" when trying to connect as per the video. I think there may not be a bootloader on the board. I purchased direct from factory rather than a hobby store. Do you have instructions for the bootloader?

[allenlong]

In your next video can you open the drop down on the power settings in both firmware I got both the 100mw and 500mw and can't seam to get the power to go higher than the 20 can you do higher?

[ashmikamadushan]

Hello, I have siyi 2.4G datalink telemetry.but it did not load this settings. Any solutions for that?

[stealthboombox]

What if mission planner says "Failed to enter command mode". What then

[drakshithkodithyala]

Mission planner is sayin failed to enter command mode when i enter load settings