Temperature controller using Arduino Labview LM35

Here's a project demo of temperature controlled fan, where the fan starts to rotate when the set temperature exceed it also indicates the different temperature conditions like cold, hot and moderate.

[josebrunocaus]

Nice ! I have one doubt. I load this VI and I just think the temperature read for the LM35 a little high. I will try to fix it

[ginog]

Great work! I see the link no longer works, is it still possible to get the VIs?

[zarjeromeable]

hello sir, is the connections in the lm35 correct? does it need to have vcc and ground connected to pin 1 and pin 3? thanks for your reply.

[zarjeromeable]

hello sir, what do you think is the error when the thermometer flashes invalid reading, how to set this up. it reads high temperature in celcius..

[salaryunis]

i tried this tutorial with a DHT11 sensor, but i'm getting a very higher values, can it be used with this type of sensor? or only with LM35?

[padmasankar]

Hi, ur project is nice. Can someone tell me where can I find the temp reading function of LINX in labview? I have downloaded the LINX package from VIPM, should I download anything else?

[BrunoHenrique-zwuc]

Hi,
I didn't can follow the instructions, I had any troubles with my program, if possible can you provide the program for me?
I'm waiting your answer.

Thanks.
Bruno Henrique

[faheemrehman]

what is the use of write to measurement file that u hv saved in excel form. kindly guide me

[abdelrahmanelaref]

Hi ur video is very helpful thank u :D
But at the beginning while I'm trying it was give me 0 reading but I entered in tools makerhub then linx then linxfrim ware wizard and choose the board and port then pre-built frim ware and then tried it the LM35 work and the temprature works but the LED didnt work and I connected like ur circuit diagram but I added the terminals of LM35 the VCC AND GRND and the common in the LED I connected to the GND and the colorS terminal to arduino board, so I did something wrong or out ? Please I need a quick reply because Im doing this a part of my project and have No time :D THANK

[Botato]

Hi i like to have a look at the vi. Awesome project!

[basmachatt]

Hello Sir, I have one question.. I want to know which type of modulation is used in this project.. Thank you for advance!

[moaiadayed]

hello can i get Labview file for this project.

[jayasigireddy]

hey I'm doing my btech project on temperature monitoring system using LabVIEW and arduino plz help me to build interface and also connections in front panel

[mustafadhahir]

hi i have 18B20 sensor but i couldint find its block in labview bow can i get it ???

[AhsanSoomro-wwut]

please also give the schematic of the arduino circuit for the help @Magesh Jayakumar

[mahalakshmis]

Can u pls share the labview file that u have done?

[zarjeromeable]

hello sir, after ive downloaded all the vis and the linx labview toolkit after i run the program ive got this error "THe specified serial port configuration  is invalid. please make sure that  COM port  associated with linx device is selected.

[Mirza]

Do you have file in labview of this project please

[dinaljoshi]

Hello, your tutorial is too good, will you please provide more details of block diagram

[muhandipras]

hello bro, nice tutorial ...

Can you provide a download link for the existing labview using? I want to download it for free ..