TB6560 + NEMA 23 Arduino Tutorial

This video is about Arduino Tutorial Stepper motor driver
TB6560 driver NEMA 23 Stepper Motor

Don't forget to subscribe!

[rusticagenerica]

Sorry but this tutorial is extremely well made ! The only problem is that due to the music, I dance while watching it and got electrocuted several times.

[GaneshHosur]

Instead of the background music, you could've explained the connections in detail..

[kzahra__]

what about the speed? what is the maximum rpm for this motor?

[boldford]

Be careful using those TB6560 modules. The data sheet specifically calls for the 5v logic to be applied to the chip first and be allowed to settle before the motor voltage (24v or more) is applied to the chip. Those module derive the logic voltage from the higher voltage using a 7805 thus compromising the power-up sequence. There have been reports of failed chips as a result. The problem can be resolved with a modification of the power circuitry.

[AtomkeySinclair]

Short and sweet to the point tutorial. Excellent. Thanks. Great music.

[shelby]

Hey r u good at troubleshooting stepper motor / controller driver issues? Ive got all 3 axis running like crap rough herky kerky and slow...on my diy cnc using tb6560 controller/ driver all in one .. Im still thinking its controller driver issue...if i run a continupus jog mode in a while the motor will go from slower feed rate grinding rough movement to smooth movement faster feed rate but only for less than 1 second...

Odd that all 3 sxis do the same thing though...usually mot all axis go bad at same time..however this is a low end junk all in one board so its possible...

[pakgurumancing]

Bagaimana kalau menggunakan 2 stepper driver?

[UdyogSutra]

which code you use here?
Have you tried this without Arduino? I meant to say with simple pulse generator and TB6560 ? If not Try. It's amazing.

[pedrotorres]

how do you find wich wire is + or -
I found the pairs of my nema 23 but cant figure wich is wich and followed the diagram but no rotation. Although the universal gcode sender shows as if it were working.

[MuhammadAhmed-vllq]

what is ampere rating for tb6560 as voltage range is 9-42V, if I use 12V supply then what should be amp rating I should use
using nema 17 4 wire

[bpositive]

I need 2 stepper motor nema 34
, controller, reverse forward switch, push button,

[kenannur]

can you run step motor with 5V usb power? how much torque you can get?

[claudenoble]

très belle vidéo, comment faire varier la vitesse du moteur ?
very nice video, how to vary the speed of the engine?

[keenanustman]

Continue to provide this useful content ... Because your subscribe and bell buttons will continue to grow ... I won't forget to be your loyal audience ...

[mnouredine]

Hello
I have a motor (NEMA 23 LDO-57STH56-2804AC)
can I make it work with A4988
THANK YOU ahead

[nivaldolopeschaves]

não dar para entender esse tipo de ligação não dar para ver nem da onde vem os fios seria bem melhor ter feito de cima com a camera mais dessa forma ai não dar para entender nada para quem esta do outro lado da tela

[GaneshHosur]

Can you send me the link of the power supply used

[jmtrader]

Ola isso deve ser uma BARBADA para quem entende ingles( Sabe ingles) gostei das fugurinhas.Ok