STEDI™ Light Bar Bracket to suit Rhino-Rack® Pioneer 6 | Install Guide

With the release of the new Rhino-Rack® pioneer 6, we see the compatibility of our existing light bar bracket continues. With only an additional step to the previous version, the installation remains hassle-free with an average installation taking roughly 10 minutes excluding any wiring.

Out of the box, you will find left and right brackets to secure the light flush to the front tucked neatly underneath. Also included are 2 additional dog leg brackets that will push the light bar out further, also opening up compatibility with larger profile light bars.

We may be a little biased, but we think this is the sleekest Rhino-Rack® LED Light Bar mounting solution on the market. Designed by STEDI™ specifically to suit the Rhino-Rack® Pioneer Platform. This is a 100% bolt-on solution that supports a very wide application of light bars.

The STEDI™ Rhino-Rack® LED Light Bar mounting bracket is designed to fit both old and new variants of the Rhino-Rack® platform including the Pioneer 6. Whether you have the four or five-plank variant, we carefully thought about the bracket geometry to suit every application.

The STEDI™ Rhino-Rack® LED Light Bar mounting bracket epitomises the STEDI™ design language. The two-piece design of our bracket allows you to mount your light bar either directly underneath or directly in front of the platform.

Shop the entire STEDI™ range:

[chrisandrew]

What width light bar will these brackets accommodate on a Pioneer 6, model 62100 (1.24m wide). I was looking at the ST3K 41.5 inch light bar - thanks

[tomgrayson]

Any tips to getting the air guides out for the first time? Obviously in the video he has had them out a few times beforehand.
Also, do you need to install them once the bracket goes on?

[BFBulletMagnet]

I tried installing this and the under support doesnt reach the rack. It has a huge gap.

[liamprice]

I brought the 42inch double row lightbar to fit under my pioneer 6 rack for my wildtrak. But the light doesn’t fit as the brackets hit the backbone, just trying to figure out what lightbar I do need to swap to as the solution thx

[gman]

With the 62101 platform, would these brackets work with the 52 double row light bar?