Siemens Tutorial | Configuring IoT2050

Check out the options available for the Siemens SIMATIC IoT2050 example operating system image. In this video, we demonstrate how to turn on RS-485 serial communication, enable GPIO, change IP addresses, and access Node Red.

#plc #iiot #iot #nodered #mqtt #cloud #siemens

[BillyShen-ij]

What is the setup digits of RS485 setup-time and hold-time in IOT2050 advance ?

[vinhvokhanh]

Can I connect IOT2050 to S7-300 via Profibus?

[alexio]

This device can only acquire data from PLC ? or make also little dashboard to control the PLC system? It seems like it works exacly like an edge device, isnt it?

[ShubhamGupta-cn]

Did you also use Raspberry Pi as an IOT device with PLC and installed in industry? If yes, then would you refer it for using it “24×7 industrial applications and environment"?

[ShubhamGupta-cn]

Is sending data to cloud is only possible using Iot gateway's only? Cant i do the same using the Industrial router only?

[DP-esxd]

Im thiniking to rum Openwrt in this device but I need to write the firmeware. What you think about this idea?

[ArpitaAgnihotri-jq]

Great Video!!! But have a doubt, How can we configure Mini PCIe card for internet, are there any connections or configurations need to be done while setting up?

[ShubhamGupta-cn]

Hardware-wise, clearly there is a difference between IOT2040, IOT2050(Basic) and IOT2050(Advanced) but application and use-case wise, how would you differentiate it? Will you differentiate it like "If you want to collect 60 variable, then you should use IOT2040" or "If you want to connect one PLC only, then you should use IOT2040 only"? Hope i'm making sense. There should be clear distinction between them application wise without causing overload.

[hugoguerratoledo]

Hi, nice video i have a problem with the iot 2050 i have configured the two ethernet adapters but only ping the last one adapter that i connect, i'm wondering if you know is that normal or there is a configuration that i dont know, thanks

[engenharianderson]

Your explanation is very good, I have a doubt, I would like to have access to the node-red image through a monitor connected to the displayport, is it possible?

[ShubhamGupta-cn]

Hi nice tutorial!

Is sending data from PLC to cloud using node-red is a fool-proof method? Meaning what will happen if suddenly the internet fails or device is turned off-turned on.