Closed loop stepper guide ⚙️📕 (Cloudray CLE23)

Guide on how to use closed-loop stepper motors. I'm using a NEMA 23 motor from Cloudray in combination with the CLE23 driver.

Affiliate links:

Timestamps:
00:00 Intro
00:07 Wiring
00:45 Dip switches
01:16 Step/Dir Arduino
01:48 RJ11 RS232
03:03 Outro

[ahmedsalah]

Hello sir, i’m going to use my stepper motor for preventing a rider from holding the brakes then releasing the brakes on a bicycle so which pin from the 8 pins should i use?

[tims]

hi mate, I was excited to find your video!! im currently having issues trying to set up this exact same motor driver combo, and want to test it outside my controller using an arduino, can you please share the sketch? you mentioned it was available in the description, however i cannot find it! thanks alot!

[RubensCampello]

I'm about to buy this same combo, 30kgf motor and CL23 with the purpose of replacing my cnc motors which are also 30kgf but open loop. What do you think of this Cloudray kit, does it look good to you? I found few videos talking about it.

[martinstrze]

Hello thanks for the video I have a Nema 34 with a hybrid drive. Everything works but the motor turns on directly when the current is switched on and the potentiometer runs counterclockwise, an idea what is wrong?

[ThyerHazard]

When I use the dip switches to set the motor to anything other than 40000 pul/rev the motor makes loud clicking noises, If i leave all dips off it works fine.

[gilleshenri]

hi

I have the same products as you, but I don't know how to configure the SW8 switch
Can you help me please ?
what speed can the motors reach??
I set the driver: "steps per" to 800, "velocity" to 3000 and "acceleration" to 300
thanks in advance
gilles

[cvncer_]

Hello Stijns, i'm currently working with this motor driver combo!
Sir if I need to get the encoder values to know the velocity in cps on my arduino board, Can I get this from the encoder cables and make like some sort of extra wire connection in the EA+ and EB+ to arduino analog pins? Or I need to make it open loop with the switch 8 of cle23 and use the encoder cables myself. I'm trying to make a closed loop velocity control for this. Thank you for sharing this knowledge.

[Dasol]

would this motor allow me to accurately drive the shaft from 0 to 360 degrees with a raspberry pi?

[smspku]

Hi... Why my motor only vibrating (it won't rotating) then driver Alarm blinking for 7times, I use HBS86H driver to drive my closed loop stepper motor.

[elsunshine]

Hello can you home the stepper without the need of a sensor just with the encoder? Like a cnc ?

[ruchiragamage]

hi can i know the make address to stepper motor controller or have a suggested method to run 6 motors using 0ne (01) usb port ?

[flemmingklynder]

Hi - where did you find the Ruitech configurator?