General Jim's / Xingbao 06022 Fairchild Republic A-10 'Warthog' Thunderbolt II Aircraft Speed Build

Today I'm unboxing and speed building Xingbao 06022 Fairchild Republic A-10 "Warthog" Thunderbolt II Aircraft set.
===================================
▶Enjoy 10 % off today! Enter promo code "Beeld"
===================================
Youtube Time Code:
00:00 Intro
00:20 Unboxing Xingbao 06022 Fairchild Republic A-10 "Warthog" Thunderbolt II Aircraft
00:35 Speed Build
07:50 Final Product
===================================
Social Media:
===================================
DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you! Thank you for supporting BEELD TM so I can continue to provide you with free content each week!

Thank you

#Lego #Xingbao #A-10SpeedBuild

[vitehed]

Давайте мы наберём етуберу один лям . Он етубер не плахой да и видео у него топ.

[BEELDBRICKS]

▶Enjoy 10 % off today! Enter promo code "Beeld"

[thesily]

You are an amazing builder. Respect to you and another sub earned, keep doing stuff like this! The build was high quality.

[mervedemir]

In this video i like your work plus i really like the music👏👏

[gunter]

7:12 lego put that as an illegal technic 💀 the studs in the middle

[thesily]

In real life, you would get the gun, and start building wings and a cockpit on it.

[Gordan_freeman]

Question, do you think a regular lego minifig would fit in the COCKpit

[luckyentoma]

Bro cool lego's i wish i had legos but my grandma put them in the fire all of my lego's😔😞😔😞😔😞

[Henry-rlkk]

aso someone who got this for chistmas its a step by step tutorioul on how to lose your sanity

[Danielplays]

I have a teeny problom with the build the wings are not shaped up

[neosquirrel]

I noticed as you put the engines together you mounted the pegs on the outside with the insignia facing inward rather than the reverse (insignia would be faced outward) but then as you mounted the unit they had been reversed after the fact.

The instructions for this are absolutely terrible to look at (minuscule in identification and tilted—and designed —incorrectly in the manual for the first two steps (the instructions show a piece with an inner ring which doesn’t exist in this set at all).

I had to watch your video at .25 speed in order to figure out what pieces went where because it’s really that bad at identifying both the large and holding pieces for the rods in three different spots.
The designers didn’t seem to have a strong enough vector program to simulate a fully round piece and in all cases all round pieces are shown to look almost gear-shaped in their circumference.

A great looking finished plane, but an absolutely frustrating build in at least ten different steps. At one point my manual was missing 8 steps—fortunately it was a mirrored step of a symmetrical piece so all I had to do was mirror it from the other instructions for that segment.