✅ ANSYS Design Modeler - Connect - Basic Tutorial 20

Tutorial about how to use the Connect tool using DesignModeler.
#Ansys #DesignModeler #Connect
Computational Fluid Dynamics
ANSYS

[akashanand]

Thanks you so much.. till now u have every problem of my solution.. hope you will solve my more problems in my further ansys studies

[gmon]

That was really a nice piece of information. Thanks brother.

[GulafshaBhatti]

Please help me to solve the error, I am connect vertices of two blocks withs same steps as shown in figure . but it is showing (connect failed) red mark. And the geometry is not connecting. why is this happening ? how to solve this?

[prorokTS]

Thank You. It's very useful in my case. Before this video, I trying "imprint faces" boolean command. But it caused errors on meshing.

[Sultaneez]

Great video bro,

And I am facing an issue where after modelling the steady flow for a 3D geometry it runs smoothly without any problems, but when I switch it to transient flow and after completing the iterations and exiting the setup tap it wouldn't update and would still show me a question mark (DP 0 error message pops on workbench), while the solution tap shows a tick but cannot be fully updated due to that issue?

I would really appreciate it if you can help me man because I am doing this for a university coursework and I am stuck on it since forever because regardless of what I do in the setup it wouldn't update ;(

[oneuniverse]

sir, I mean how to generate connecting meshing when we have many parts bodies and I don't want to mesh them by making them one part?

[Dan-cldi]

I can not use "connect" in 2D surface for connecting edge of two surfaces. The error message is "Cannot connect isolated edge". Could you help me with this problem?
Thank You.

[chemicalengineeringhacks]

Cannot Connect Isolated Vertex. Bothe geometries are in different planes.

[mdzishan]

make a video nozlw shell v groove butt weld joint

[agroskynd]

useless interface, too hard work for so simple action, 14 clics only on buttons,
not considering model manipulation, when in other programs u need only 4 clics

[-dq]

Please help me to solve the error, I am connect vertices of two blocks withs same steps as shown in vedio . but it is showing (connect failed) red mark. And the geometry is not connecting. why is this happening ? how to solve this?