Mazatrol Matrix Nexus: NC DATA BACKUP. Manual Backup

This video shows how to manually create an NC DATA BACKUP.

The NC DATA BACKUP function creates backups of parameters, programs, and other NC data.

Automatic backup
This function creates backups during the start of the NC unit.
Automatic backup becomes valid when “1” is set up at bit 7 in parameter F166.
When the machine is powered on next time onward, backups will be created automatically at the start of the NC unit. Automatic backup is indicated by the corresponding message on the screen.

Outline
This function intended for rapid restoration in the event of erroneous data deletion, for example, creates backups of parameters, programs, and other data at the start of the NC unit or in desired timing, in order to restore the normal state of the data concerned. So if the HDD (Hard Drive Disk) or SSD (Solid State Disk) fails; the machine can be restored easily to its last status and won’t be required to perform a new machine SET-UP. All data as part program, tool data, tool offset, etc will be restored to the date and time according to the NC DATA BACKUP time stamp.

IMPORTANT
It is HIGHLY RECOMMENDED that operations perform this NC DATA BACKUP every time a new SET-UP is finished. It takes half a minute, and it will save too much time if any NC failure.

[camb]

Good day Nestor. Could you help me with the parameters for 640T Nexus? I have a similar machine and need to review the paremeters. Thanks in advanced, it's quite urgent