Brilliance Laser Inks - How to Laser Etch (almost) Any Metal - 1 Minute Guide

---------------------------------------------------------------------------------------------------------------------

Easy 5 Step Process for Aerosol Can Application and Laser Marking.

Chapters:
0:13 1. Clean: Wipe the substrate with alcohol so it's free of dirt and oil.
0:20 2. Shake: Shake well for 2 minutes.
0:26 3. Spray: Hold the can at about 45 degrees and about 6 to 8 inches away from the substrate. This process is similar to spray painting. Make sure it's a well-ventilated area, or use a spray booth with an exhaust fan, especially if working on a large surface. No need to overspray.
0:32 3b. Dry: The spray will dry on its own in a few minutes. (Optional: you can speed this process up with a heat gun or hairdryer.)
0:36 4. Etch: Use a C02 or Fiber Laser to etch the desired mark. In the video, we used a Trotec Rayjet50 30W CO2 Laser at 20% Speed and 100% Power. Settings may be different for other lasers or grades of stainless steel.
0:45 5. Rinse: Wash or wipe with a wet cloth. No need to wait after marking.

---------------------------------------------------------------------------------------------------------------------

✅ 100% SATISFACTION GUARANTEE OR MONEY BACK: Settings and marking techniques may vary depending on the laser and metal product being marked. We can usually resolve most marking issues with simple setting adjustments. Please feel free to contact us directly.

✅ HOW TO APPLY: Shake well, Spray 6-8 inches from the substrate surface, apply a thin coat using left to right motion, as long as you do not see through the surface, do not have to overspray.Use the suggested laser settings in our FAQ section as a starting guide line or feel free call our Technical Support Team.

✅ BEST VALUE: Proven Anti-Clog, nanoparticle-technology of Brilliance Laser inks that allows 25% more coverage surface area than competition, with a thin coat spray (may need some practice initially). Hence more profits and less spend!!

✅ GENERAL GUIDELINES/SETTINGS: Scan QR CODE on product label to see our suggested laser settings in our FAQ section of our website. CO2 LASER - 25 Watt Minimum Required (100% P / 15-30% S / 500-700 DPI). FIBER LASER - 10 Watt Minimum Required (@ 10 Watt PWR / 50 mm/sec / 80-500 Q-Freq. / DPI- 0.1mm Hatch) Low watt Diode Lasers are not recommended.

✅ MULTI PACK DISCOUNT: Get more discount (SAVE with our bundle options, check out our listings with multi packs. Also available in Powder form.

--------------------------------------------------------------------------------------------------------------------

Credits:
Shot and edited by Dan Hu

Music:
Creative Commons — Attribution 3.0 Unported — CC BY 3.0

[wongeunyoon]

I saw the video well. Can I dig it up with an intaglio? That means digging it out a little so you can put the collar in it.

[lorenzostewart]

Can it work with the 30w CO2 Galvo laser?

[smoovlatino]

Is this just for CO2 lasers or does this work with fiber lasers as well?

[victorbrown]

Would love to use this but $60/can makes it bit prohibitive fr me at this time. 😒

[BleachNoose]

When I use this product, it turns out gray instead of black, any remedies?