Cooler Master MasterFan MF140R ARGB Unboxing & Review

Fan Size: 140mm
Bearing Type: Rifle
650 - 1500 +/- 10% RPM
Air Flow: 90 CFM (Max)
Noise Level: 33.5 dBA(Max)
Power Connector: 4 Pin
LED: Addressable RGB

_______________________________________________________________
TWITCH

TWITTER

FACEBOOK

INSTAGRAM
_______________________________________________________________

[stevec]

Thank you for pointing out the cable length.

[frostedlambs]

you dont need massive cables on a fan, the reason is because of cable management, if you need a longer cable you can put an extension on

[draco_vsgaming]

Your pc is coming along nicely! good job and nice unboxing

[marXtevens]

I appreciate the video. I purchased these for my C700M and planned to have them mounted on the top (chimney configuration) and the cables are all too short to reach the controller.

[nanmusha]

Hello.. Thank you for that video. Can you tell me how did you make the top rgb strips to work with no front panel? In my c700m only the bottom lights work with no front panel' did you made any changes ? Hope you can help. Thanks again.

[gpersonal]

the 1080. Remember when it was “the” gaming beast?

[highlandermccloud]

Try the cable from the other side of the fan. If the cables in the case were to hit the fan, it would not be from the side you are doing it from...

[FischiPiSti]

The safety sensor does work, I learned it the hard way...

[timmordragon]

Cable Length does suck. Thanks for the warning.

[Tullerion]

You have to get the fan to stop 1st.. It stays stopped for a few seconds before starting back up when it detects its no longer jammed....

[RaveStrike]

I have a H500M case and just ordered one of those fans for the rear, I hope the cable is long enough. The built in controller is also mounted near the back of the case so it might work ^^

[darrellcardwell]

The individual fan is meant to be purchased as an add on with the 3 pack and controller

[Andreas.Michailidis]

Hi for you I would like to ask I have a Coolermaster C700P and in RGB Lighting Control I have connected my motherboard Gigabyte Aorus Z370 Gaming 7. From the Gigabyte RGB Fusion program I change colors to C700P. If I connect a MASTERFAN MF140R ARGB onto the RGB Lighting Control that has the C700p I can change color to the fan through the RGB Fusiom?

[JoeHanayama]

You can connect the RGB cable of this cooler: MASTERFAN MF120R ARGB In this socket ?: Addressable LED strip header

[waveillustrator]

7:33 you are suppose to use AURA sync, msi mystic of course there is no software pre intalled

[uberyoutuber]

hi nice video. I am researching ARGB fans for my build. Would you buy and use these as your fans for your build given the number of choices out there if you had not bought these? also for your follow up video would like to see how the fans look in the dark, and on the back side from inside the case, also in the dark. the only constructive criticism on the video I have is that I had to turn my sound up to hear you, and then at the end when you stopped talking the music was about 3-4 times louder and it startled me. overall nice job on the video! :)

[rdgcoverV]

Hello I'm in doubt with these cooler master fans, if I can put the 3 front ones without extender on the cables? TKS

[wheelsdeal]

If you just plug the 4 pin connector without the controller do they light?

[HaroldoNVU]

I wish I had seen this before ordering a couple because those cables look way too short. I'm using them to replace the stock top and back exhausts fans on the NZXT H500 and I hope they are long enough to reach the fan headers on the B450 Tomahawk.

[KevinArcade]

I have a CM 690 II case it just has a LED on and off button. Would this work with my case?