Load Pro test leads...how to find bad connections and resistance.

These are the Load Pro meter test leads, which I showed in my last video...but I didn't have time to show their use in that one. So, here they are. These work with any multimeter and are a really useful diagnostic tool, especially for the vintage buses (and old wiring) that I frequently work on.

This is not a sponsored video - I've just found them to be a good addition to my meter.

[jeffreysmith]

I absolutely love this took. It has never failed me once I learned and understood Dan Sullivan's way as looking at electricity. One of the best inventing in the last 30 years.

[bernardocisneros]

Great video! You made it very easy to understand how the loadpro works. I've watched other videos but all the ones I watched only show how to use it while troubleshooting a circuit in a vehicle. You're presentation was more of a "classroom/lab" demonstration and using a resistor, wire with corroded terminals, and rusty bolt made it really easy for me to understand how the loadpro works and how, when, and where to use it. Many thanks!

[lukesebree]

I had no idea such a thing existed. I work as an RV tech, I can think of soooo many instances where I would have loved to have something like this. Ordering some now, thanks for the video and explanation!

[bekomcar]

Thank you for the benightment. I purchased one myself recently and thought I should have known LOADpro way back earlier. It just gives me peace of mind in diagnosis.

[ricardobrathwaite]

Trying to find out where you got the alligator clip for the ground probe.

[storesmemberships]

Can be this used not with 12 volt connector and instead reference voltage ( 5 volts) for sensors in automotive?

[jamesbew]

Would this still work if say you 5v circuit but had 12/24 batteries would you need a 5v power supply and not the battery power

[killnconquer]

What does the wiring look like, you’re connected to a 14v battery and then the probe to the multimeter that’s it? Is the other lead connected to anything?

[MikeEvansHfd]

Can I ask where you got your crocodile clip for your earth lead from? I can’t find one that fit well to the loadpro leads well.

[nicholasphillips]

Being somewhat new to this I’ve got a potentially dumb question: once you find there is significant resistance in the wire or wherever, what do you do to fix it?

[leroyjohnson]

Hi, is this tool safe to use on 5v sensor circuits that are switched on by key on/directly from the ECU/ECM/PCM? Will the load not damage the circuit board on the module? Thanks

[Richard-ptym]

You have your fingers touching the probe and connection. That alone will give a false reading.

[newry]

When add the load what would a good connection read, thanks

[binnsbrian]

The wire it's self will have some resistance.

[JohnDoe-spzg]

Bad set. Don't make a video and a work bench. Take the tool a connector and show us a real world test.