1970 CHEVY NOVA PART 7 SUB FRAME CONNECTORS

Competition engineering bolt in Subframe connectors installed plus leaf spring bushings

[gatorunleashed]

Nice work,   I'm about to begin the same job on my 71 nova,   thanks for the video.

[braddock]

Thank you Sir for posting this vid . Helped me with my project..

[singeria]

Are those the ones form Competition Engineering?  They look good.

[RendSeven]

What brand of subframe connectors are you using and do you know how long they measured? By the way, where did you grab them if you dont mind my asking?

[mark]

Good job!  How difficult was it to lift the body up high enough to replace the four bushings and bolts?  I have the motor and suspension out so thought it might be the opportune time to do it but heard it was a pain to line the four holes back up...?

[Mendez]

Were did you get that sub frame connectors

[theshark]

Do you still have mono leaf. Im not sure if i should upgrade to multi.

[KevinSanchez-ltds]

Where did u get the sub frame connector and how much did it cost?

[Jim-kmqd]

The car should be sitting on the tires when you install sub frame connectors.

[RoyalTDynoman]

What kind of subframe  bushings did you use? how is the clearence at the front spring perch? Do you think you could run a set of Cal Tracks with those connecters ?  Thanks for the Video!

[scottroe]

nice job but honestly you should have waited until the everything was done with the car and full weight of the vehicle is loaded on the suspension and chassis meaning install the subframes on a drive on lift. The reasoning for this is because now you will more than likely have some unsettling issues with the vehicle.

[backwoodscustomcrap]

The motor should be in it to be accurate