Danger Zone Combat Robot (V3) Build Log

Here's my ant weight (1lb) drum spinner for this year's CIRC Bot Brawl.

To contact me about projects, please visit CarterHurd.Com

[loganhughes]

Do a danger zone vs crave monster video!

[Potato-ydhv]

I'm not gonna lie, but I think your first design of Danger Zone was the most successful.

[loganhughes]

Yes Danger zone is back! BTW I think this new drumb will work great! You should also (after the compatition) have each of your robots have a grudge match against each other.

[loganhughes]

Next year you should make the body heavyer than this year. You should also put rubber bands on the weeks for traction.

[teamscrewup]

Can't you put tape over the electronics areas to keep them in

[Lumakid]

To prevent your weapon motor breaking, battle harden it.

[i_am_potato]

This may not fail but its always a 50 50

[teamgetwreckedcombatrobots]

What battery do you use? Also this is my favorite Danger Zone so for. Keep up the good work.

[lilbakivevo]

Is there anyway to find where the competitions are and if there’s one near me I took a few robotics and engineering classes and was pretty good at driving them and would love to do it again

[pastel_pink]

What is the software you used at 0:17?

[mrsqueakyvoice]

Did you see my comment on your last video? Bot has to fit in the 12" x 12" in the fully extended position. This means Krave's tail is technically illegal. They might let it slide but they might not. I think last year was ok because each half of the multibot was small enough to fall in the pit, but Kraves tail poses a tiny but non zero chance of interfering with that. Not trying to be a dick, just pointing out something I think might give you trouble, I assume you didn't see my last comment bc you didn't respond. Worst case scenario you might have to clip it. It's not a big deal but I would suggest emailing Bruce just to check.