Antec One Hundred - Component Installation

The Antec One Hundred is a mid-tower gaming case aimed at value minded users. The Antec One Hundred is part of Antec's gaming series, inheriting some attributes from its siblings while improving some features that were previously lacking in other Antec cases. Fully painted black inside and out, the Antec One Hundred has a sleek straightforward look, designed for high air flow performance. A 140mm exhaust fan at the top and a 120mm exhaust fan at the rear come pre-installed in the Antec One Hundred, with the option of adding two intake fans at the front and one more at the left side panel. Users with plenty of peripherals will find the top mounted accessory tray convenient, especially if these are gadgets that need to be plugged in one of four front panel USB 2.0 slots. Even though priced for the budget segment, the Antec One Hundred offers more than the just basic gaming needs.

[mandigal]

So that's how to remove the front cover... I wanted to get to the front panel (audio issue) but couldn't see how. It's a nice case still using mine, plenty features for a budget case and nice finish. Thanks for the video.

[HiTechLegion]

As long as you pull it straight and not from the left or right it should be ok. Just make sure it is aligned right when you place it back though, I have damaged more front covers that way than removing it.

[lifeisaliewithoutaf]

@MAGGI0MAN in order to get usb 3 speeds u need a mobo that supports usb 3, the only time you would need the case to support usb 3 is if u wanted to have usb 3 ports at the front of ur case which this does not have. usb 3 connectors are different, usb 3 can be used on usb 2 connectors and plugs but you wont get the full usb 3 speed unless you use a usb 3 connector or plug

[HiTechLegion]

yes USB 3.0 ports use 20 pins to connect so there is more bandwidth. USB 2.0 however uses 10 pins.

[sungoh]

I believe the power supply was installed backwards. I had the same installation but my power supply overheated because the intake side was taking in hot air from the inside of the computer. I suggest you re make the video before you confuse other people with antec 620w PSU

[jeffledp]

How do you take off the front cover? I just bought this, but it feels like it's going to break every time I try to pull from the bottom.

[AmaZINProKiller]

Would it be a good idea to drill additional holes for the PSU fan at the bottom?

[DannyOvox]

my antec one did not come with those sliders for a hard drive 3.5! instead I have like some rubber stoppers but idk what to do./ help!

[ax]

Question! In order to get full USB 3.0 speeds, does the case need to say that it supports it? I cannot imagine that the connector would become a bottleneck, but are they any different than 2.0??? Thumbs up so everyone can know the answer! (including me :p)