Configure Palo Alto Networks PANOS SDWAN

Through this video, you will learn how to configure paloalto panos sdwan.
for a detailed guide refer to the following link:

[chrismach]

This was a great and concise explanation of Strata SD-WAN and its initial setup and requirements. Thanks for the vid, I think you've earned another subscriber!

[Neurbit]

Fantastic explanation and demo. Bravo!

[richardrugambwa]

Nice video and good explaination.
Why do we have the sdwan.1 manual VIF since the Auto-VPN is creating sdwan.902? Can't it cause a conflict.

[mostafasafari]

Thank you for your video.

I have a bunch of branches and one hub. These branches are currently connected to the hub by IPSec tunnels, one for each branch. The tunnels are also part of the internal zone; therefore, we have L3-Trust (the internal network and tunnels) and L3-Untrust. If I want to use SD-WAN, should I define a third zone for tunnels? How should I map the zones?

[aswin]

Can we have Branch to Hub and also branch to branch ? also can we route an application through specific link ?

[gouthamm.n]

Could you also show the virtual router configurations?

[TranVanLamBDCVT-]

Can you show me the Zones on the Panorama ?

[spm]

Much appreciated, May I know the difference between the above configuration and the CloudGenix ION device configurations from Prisma-SDWAN portal.

[kauffmann]

Hello, Panorama is not necessary in order to implement SD-WAN, right?