$500 Porsche to SUPERCAR! — Engine is Finally In!

Project Jigsaw continues! This week we get the engine and transmission mounts made and the engine installed. Come along as Tony and Ryan problem-solve the complex engineering behind this project, and take jabs at each other all along the way!

#vintage #supercar #porsche #lamborghini #ford #racecar #hotrod #restoration #fabrication

[BSpenceTravels]

Hell yeah, I love seeing this project come together.

[StingrayOfficial]

Waiting for this channel to blow up. Love this fabrication.

[JonFukuda]

That cylinder profile gauge was clutch! Great ingenuity on the fly! Love the just in time problem solving you bring each week! 🔥🔥🔥

[scottmcclintock]

That tube gauge is f$%’n Brilliant!! I Love this channel and the level of metal fabrication.

[Isryal]

For the type of content you guys put out you should be much bigger than you are. Good personalities and great vibe.

[avshunmeckaneck]

Put a rubber band or hair scrunchy around the center section of the tubing profile gauge that you printed.

[rolexmd]

We love it boys.... Keep up the great content. Love the one off projects and that's all you boys do so it's a winning proposition

[veryscaredbunny]

This has been a lot of fun to watch and I can't wait to see what it's going to look like.

[dimitristsalatsanis]

immense project, my head is spinning .. Bravo

[stephenschofield]

Great work guys, I just want to know how the hell you only have 50K subscribers when you not only have fun, but also explain your work far better than most. Thanks

[EJerk]

Great stuff guys. Just a note there were hydrolic lifters in the 60s as well as hydrolic breaks ect. I like how you show the whole fab process c.a.d. cardboard aided design is something any one who turns wreches should use.

[shaneomacgardner]

I love this ❤
Btw you could give the filler wire a very light tap with a hammer to bulge it out, should stop them sliding too easily in the profile guage.

Keep up the awesome work!

[Gen_X_George]

you desperatley need to increase your air pressure to the plasma cutter...like 80psi behind it.

[foxbatmotorsports]

How about interlocking tube clamps? Trail-Gear Chromoly Interlocking Tube Clamps 180114-KIT

[joshmcdonald]

Aaaaah, I get it, it's a circular contour gauge... Genius!

[JF-]

Great video but you need better lighting of the underside of the car. Hard to see what you are doing a lot of the time. Maybe an ped panel on the floor would help. 😊

[bigmonstermandd]

You'll be on dragons den or fish tank with that little contraption!

[drwnd.porsche]

Wondering about the engine…they only make around 200hp. It is going to be rebuilt?

[williamhardes]

please tell me the suspension cradle and the way the mounts are made is all temporary!

[ralfwenzel]

how much do you stretch the wheelbase? regards from germany