RaspberryPi to PLC Codesys step by step (controling GPIO's)

Links Codesys:

RaspberryPi Link:
(download noobs)

Electrical drawing:

[gr]

probably the best explained video of codesys. Every time I reconnect to my rpi and I don't remember anything I look at it and I think of course, thanks

[IngVasiu]

Thank you! It is the same procedure as with the BeagleBone Black.

[davidbotros]

This is great and very helpful, thanks for sharing!

[darinschollmeyer]

Thanks for making this, was really helpful.

[javieruribe]

One question, I'm doing an investigation work for my university and i'd like to know if there are any limitations besides the 2 hours use, if I don't get the License from Codesys and i use the Demo. Thanks, and very good job, it really helped me

[unitedbolts]

Hello, I have a question: rasp can recognize usb ethernet adaptors? (those usb to eth cables).
I wanna try to use ethercat master with softmotion but need 2 eth ports. One for tcp and other for ethercat...
I use codesys with several different plc brands but they all cost too much and I am looking for somth cheaper.

[franciscoflores]

Thanks for the video, it helped me a lot.

[djscottdog]

This could be the thing im looking for

[kooswijling]

this is amazing
go mainly by making these videos

[jonstonloreto]

hi do you know how many input and output can used for this applications, what is the limit of input and output? thanks.

[rodrigoadachi]

Se puder atualizar os links, todos estão quebrados

[pedrot]

Hi, I'm using Raspberry with Codesys using a PSOC 5LP in order to expand the raspberry I/Os. I'm using i2c bus, but when the data is received on raspberry, it started to oscillate between 255 and the true valor. I've used the pull up resistor (4.7 Kohm), but it still not working as well as I wanted. What`s wrong?

[fliper]

Please help..
I bought Raspberry pi 3 and by default it has IPv6 switched on.. I can't switch it off and work with IPv4 so I can work on this project.. And I would really want to adapt R_Pi3 for codesys because I use it for a few years on some really expensive PLCs..
Thanks in advance..

[foufoutoutou]

thank you for this video, please can share again the link to upload the programme, because it's not availble now, thank you in advence

[parththaker]

im using raspbian and wifi for connection rather than ethernet but my gpio pin not work when i start this, please give me solution for that

[최대한-sg]

question

1. you raspberry pi connection Ethernet? (internet connect?)
2. raspberry pi booting -> browser autostart -> ad : localhost:8080 (not internet)

[raer]

i got one orange pi . if i set rasbian on opi then its gonna be run on opi ? how can ı use with opi ? thank you .

[deadpumpkin]

can you please explain your hardware configuration, also in case of extension of gpio pins what should be done to increase numbers of gpio pins, also what should be done to take analog input/output, what are hardware is available for it and how to program using codesys?

[qzorn]

very nice info, how would an Automation Direct Cmore HMI Ethernet/IP program work with this demo? thank you

[servertigo]

Hello, I have a problem. It doesn't show the web Visialization in Visualization Manager (It shows Visualization Manager without the plus-minus box on the left). How can I find it or sore it?