Old Rusty Bench Grinder Restoration

My father's grinder has been idle for about ten years. In summer, it was eroded by rain. The bearing was seriously rusted and damaged. So this project is to repair this grinder

[remcotissink]

Nice work ! Nice touch measuring the insulation. Should have used a grommet though for the hole where the cable leaves the casing. Now you'll cut the insulation slowly but surely.

[Markanthony]

Got bored and wanted to watch restoration videos.. this is an epic video thanks for the long video.. good job bro

[metelgodful]

That was amazing that was a nice job really awesome but how come you didn't take the dents out of the front of the covers over the wheels those standout big time now you could have pounded those two things in place and it would look even that much better but you did an awesome job it just makes me wonder how come you didn't take the dents out of the covers

[_BLANK_BLANK]

Did you put the screws in muriatic acid to get the rust off?

[jblcontrolcrossover]

7:13 Never hammer on the end of a shaft like that. The end of the shaft will mushroom slightly and the nut will no longer thread onto it properly. Protect the shaft by threading on the nut to a flush depth so that the hammer hits both nut and shaft at the same time. Or, use the correct tool for this procedure... a press.

[maxc.gurrero]

Marvellous video. Really appreciated your hard effort.

[evelynsia]

What's the name of the liquid u use to clean the bolts?

[waltercooling]

This project was very professional. Did you balance the wheels? On your install, one looked terribly wonky. Most actually are, unless they are high-grade stuff. Very smooth, enjoyable video!

[rustydogrustydog]

Excellent job. I would maybe consider not using the old grinder wheels as they are probably compromised.

[TEST-xrki]

Hello what is the liquid that remooved the paint? Nice job i will follow your videos.

[dbeckley]

You do great work but take some advice and get some brass punches and avoid striking hard metal together this will eventually save you a headache.

[carlosconstantino]

Tenho um esmeril ele só funciona deitado o que devo fazer

[joseanecruz]

O nome do equipamento 11:40 que gira manivelas?

[ikju-ilok]

Didn't see any capacitors? Can anyone help?

[metelgodful]

You did a real awesome job on the grinder but the two things you should have finished was those smashed in dents on the front of those covers for the grinder and the rubber pad for the bottom you probably could have took to the sink and washed with soap and water I bet it'd look a lot better I mean cuz you took that thing all the way apart to the even taking the motor out of the casing I mean you went that far as you did why didn't you go to that extra couple minutes and finish those two things then it would have looked brand new and maybe clean that label a little bit too you'd be surprised with soap and water can do I took a plastic gas can that was dirty and left outside for a long time but a new spout installed an air vent and washed it with soap and water it looked brand new when I was done

[Markanthony]

Whats the liquid u used to get the old paint off?

[oldgadget]

please dont use a hammer on a grinding wheel. bad things happen to stones that crack and fail