chevy crank thrust fail

preview_player
Показать описание
what happens when your thrust bearing has too much play in it? Check out this damage to see!
Рекомендации по теме
Комментарии
Автор

Wow, that was a detonation waiting to happen!

IA-shyu
Автор

What was mileage ay??? I own 02 gt mustang for 14 years now it's a 5speed I've often thought abt just this my old girl's still got original everything engine n trans but I put 4:10gears n rear end 13 years back n changed speedo gear to fix odometer n headers no cat X pipe 40flowmasters n dyno tuned with updated puter chip my baby's got 320000.0 miles on her always ran mobil1 full syn 10w30 with can Stp n can of restore n Ford motocraft filters she stays clean n yet to move on dip stick

scottyjones
Автор

I know this is an older video but I imagine that was making a lot of noise while it was running.

Boots_And_Slicks
Автор

I had one of those. Scrapped counter weights and all. On mine, the bearing was worn away, not the crank. I wonder why? Mine was an auto. There is a video on youtube of a 4l60e pushing, hard, on an engine. You dont realize that stuff can move back and forth so much, until you see the video. I'm pretty sure my trans is what wrecked the thrust in my 01 4.3l

briansansone
Автор

so whats the sound of this pile make @ idle, clutch in, clutch out, on it, off it, ,ya know? just sayin

dano
Автор

was it using antifreeze ? there was no babbit left on the bearings either

markb
Автор

Was making a rattling noise in the engine when it was running

nathanscullawl
Автор

also laying on the clutch at stop lights don't help...it presses the crank forward, rough use will do it.

dgaz
Автор

What was the end result of that motor? Was the block scrapped or did you install all new bearings and now it is running great?

canuckfixit
Автор

If your thrust bearing fails and the crank rides on the block is the block scrap ?

carsonraines
Автор

Will that wear out your transmission or torque converter

jwolf
Автор

Is the block still salvageable? have a 327 with bad thrust bearing and would really like to know if i could save it with a new bottom end? Thanks!

HigherVibrationsNW
Автор

I don't know why everyone loves these motors I have had bad luck with them

kyleeasterly
Автор

what was the root cause of that to happen

brookewoody