CR-10S Unclogging The Nozzle

Since a friend left me his printer a Creality CR-10S, to work on it and solves some problems, one of the problem was a clogged nozzle, this is a big printer let me show you how I have done so and the technic I used.

Videos that might interest you:

You can also find me on :

My gear :
Amazon US (Commissions Earned):

Amazon Canada (Commissions Earned):

Hi, I'm Frank my channel is all about 3D printing. I can't get enough of my 3D printer. I make everything and anything out of 3D filament (PLA, PETG and more). As I say a printer that is not printing is a missed opportunity.

I'll be doing electronics, mechanics, computer engineering, DIY, reviews and tutorials.

I update twice a week on Tuesday and Saturdays.

Subscribe to my channel, and don't forget to turn on notifications.

[champagneave]

I love how you can explain it in 2 minutes

[N-VAMusic]

ugh what a lifesaver I have been fighting this damn printer for the past 3 days before I gave up and looked up a solution lol thank you!

[Jayr]

Quick, to the point and very precise....awesome video!

[nordhbane]

Thanks for this great short video. Helped me solve my first clog.

[Alpentarn]

Good hint :-) I realized earlier that pull out the bowden tube was impossible. Seems you have to loosen this fitting as you described

[BLACKSYNTH]

great! I always just remove the Nozzle and heat it up with a blowtorch in some vicegrips. and push filliment through it, let cool pull a few times untill its clean. I can really get my wire brush on it too to, heats up in seconds with a torch and the metal vice grips act like a heatsink so it cools down fairly quick too. :)

[guygarritson]

This worked great, I actually bought a nozzle tip cleaner and that really did not work for something like this where the build up is inside the top of the nozzle chamber... thx

[terrywinkle]

i cant get the part you use the wrench for to come loose i’ve tried really hard

[kylekuhn]

So I undid the top nut, but I can't pull out the bowden tube? Any suggestions?

[aeroiugfhefsiughsidfugh]

so what if the tube isnt going back in after cleaning...

[andrewdowney]

If my filament keeps breaking when I pull, should I try a higher temp pull?
Thanks

[sovideo_]

Useful video. Only the temperature to pull the filament is too low. Try 120 degrees C.

[cyno]

I did it exactly as shown in the video and the tip or the filament broke off inside the nozzle. I dont know what to do

[bryanwhite]

My Boden tube is stuck in the hot end. Removed the fitting as mentioned but tube still won't come out of hot end. Tried pulling quite hard and that didn't work

[jonhuss]

Hello, I have A Creaity CR-10 with Dual Z Axis motors. The z axis goes up and down when homing but will not go up when printing. Is this a problem with my machine or am i doing something wrong in Cura ?

[brunodeconinck]

Hi! What can Ido if my tube is stuck inside? o.O

[Ahmengmalaysia]

Hi, how long once to perform this procedure?

[ClassyTechTime]

I can't get my filament out it is stuck!!!?

[DashDapper]

Did everything except unclogging the actual nozzle. Smh