How to install an Outdoor Hot Water Heater.

preview_player
Показать описание
A video that shows you how to install a hot water heater on the outside of your home.
Please like, subscribe and hit the little bell to get our new videos.
Installation by Outien Construction, Robertson.

***************************

DiyMovies SA was created by film maker Don Morris to give homeowners and those interested in d.i.y. projects information and templates to work from that will make any job much easier, save you a load of money as well as help you to achieve a great result.

If you find value in these videos please consider becoming a channel patron,.
Donate a few dollars for every video that I produce to support me as people used to support artists in the past.
The artists were able to work full-time on their masterpieces as they received money to support them every month from generous patrons.
Рекомендации по теме
Комментарии
Автор

My husband connected our geyser up following this video and it's been 2 months still going without problems thumbs up to the 2 plumber's in the video and I notice they from south Africa by they language lol great jobs

wafiqahcarelse
Автор

I'd like to say I was xtremely high and watched this video about ten times 🤣🤣 it really helped with my installation

ethanalexanderpatience
Автор

Very helpful and to the point. Some of these “how to” videos tend to spend 9/10 minutes talking a lot of nonsense and the actual video is just a minute long. Good job and thanks for sharing

Pyxe_ZA
Автор

Good video. However it is important to note that when installing a geyser, there is need to balance the pressure on the cold water supply i.e. cold water for the rest of the house and for the geyser supply.
To achieve this, cold water supply to the rest of the house must be connected after the pressure valve. So its pressure valve, tee junction (house cold water supply and geyser cold water supply) and straight valve
Now if you do that you achieve a balanced water pressure on both cold and hot water. Thank you

tinashel.gadzikwa
Автор

This is a good job, would’ve loved to hear about the power supply but great job by the guys.

tdyani
Автор

These guys just saved me 3200 rands on labor, I called my friend, we did it and bought booe and meat for braai

nsilayenja
Автор

Why are the vacuum breakers being referred to as solar outlets?

Also the anti-syphon loop is sitting lower than the top of the "water heater", it should stick out above.

jvandervyver
Автор

What a greatest content for DIY... just watched this vid and then subscribe to the channel 💯.. hoping to learn much from you

njabulohonwana
Автор

well done for trying all plumbing systems need to be balance otherwise warranty will be avoided on all plumbing mixers

pietersmith
Автор

THE BRUIN OU, IS THE MAIN OU!!! 💪💪💪 KUDOS TO THESE OU'S, THEY ARE YSTERS IRON🛠️🔩⚙️

jay-peephillips
Автор

If my tank is fitted underneath my bath ceiling the two vacume green breakers do these have to be installed if fitted horizontally

trevorelgram
Автор

Those "solar outlets" are called vacuum breakers. They allow air into the system and play a role in preventing back siphonage. The anti siphon loop in this installation is too low, the horizontal run of the pipe should be higher then the top of the geyser. The cold water supply to the rest of the house seems to be absent... That would normally come after the PRV to ensure balanced pressure in the installation. Sheesh. Guys please call a plumber instead.

matto
Автор

Ahh copper pipes, if only they werent stolen so often in SA would be nice😢

christophernaicker
Автор

Please, teach that bloke to use a copper cutter 😅

aurethlouw
Автор

How do you clean the pressure valve cartridge behind the geyser tank? There is no syphon loop on this install?

liampringle
Автор

I am learning from you guys, thanks a lot.

motswadiwamonna
Автор

I have a 600kpa gyser but the pressure control valve of the cold water inlet to the geyser is 200kpa. Can that be the reason I get low pressure on all the hot water taps around the house? Thanks in advance

otherman
Автор

Next time mention the pressure valve on the hot outlet side.Mention also that there must be a 30 amp external breaker box .Otherwise good clip

richardduplessis
Автор

Just a question why do you put ptfe tap around the ring of a copper pipe. Didn't think you needed to do that

mikethesparky
Автор

My geyser was ook buite, totdat diewe die koper fittings kom afbreek het. Volgende keer elektifiseer ek dit.

gemi