REBUILDING KTM 48mm OPEN CHAMBER FORK SEALS | New seals and oil!

It's about time we do the KTM 48mm Fork Rebuild. Not only are they built and ready to rip, but we added some bling factor. Go check it out and let me know how I did!

Thanks for watching, if you enjoyed the video give it a like and please subscribe to the channel! Share it with your friends and we will see you in the next one!!!

⬇️ As always the links to the tools, parts, and equipment I use are listed below! ⬇️

----Fork Rebuild Gear----

------GoPro Mount------

------Check out my Camera Gear------

**Disclamier - As an Amazon Associate I earn from qualifying purchases.**

------Join me on Social Media------

#danmx #ktmopenchamberforks #ktmforkseals

[danielbrodeur]

je vais faire les miens cette semaine, tu met d'une grande aide!!

[cryptotron]

Simple and straight forward, nice video.

[rocksbrains]

It is not so obvious which side is out on the oil seal. If there is any writing on the seal that should be out. Ive inverted it before and was not able to get the C clip in place as a result. Also, a little heat around the fork sleeve will aid the lower bushing to seat easier.

[nullbyte]

Awesome videos man you have made my life so easy when it comes to rebuilding my 2005 ktm 125sx I love your content and tips and tricks!!!! I've watched all your build videos. One question my bike has "white power upside down 48 ma forks" are they the same as the ones you rebuild on your bike?

[jasonludlow]

Hi Daniel, your video is the closest type of KTM forks I can find on Youtube. I'm busy with fork seal replacement on a Superduke 990 (WP4860). The springs inside these are much shorter and stiffer so I'll have to find a way to compress them to turn off the nuts underneath. Please could you tell me what those bleeders are for that you installed at the end? Any help will be appreciatted, thank you!
Jason

[crazybalony]

Are there forks that do not have that spacer bushing? I have a 2011 Xcw 300 and when I opened the forks this weekend, to my surprise there was no spacer bushing (the long 6in tube spacer). ??

[DedyHariadi-hz]

Hello I'm your follower from Indonesia, I'd like to ask how much oil measure lowring 5 cm wp and how much oil does not use lowring. I hope you can help me. thank you very much.

[rasmuskarusalmi]

Hey man I hope you still answer to these comments but I dont have that seal driver thing 16:01 and I wondered if there’s any other tool that can be used to do the same thing that the driver does?

[bloodyholly]

Can I loosen or remove the lower nut valve while in the triple clamp? Trying to accomplish 2things partial drain and it’s tough to loosen that nut valve one my bench with no vise or help

[pascocrocodele]

hallo bos is fork wp 48mm from 950ktm supermoto 2006 ???

[topikettunen]

What is specific name for this tool (6:00)?