How BT136 works simplest explanation #bt136 #electronics #triac #accircuits

Working Principle Demonstration Of BT136 TRIAC.
This video demonstrate how BT136 TRIAC can be use to trun on the blub as an touch sensor mechanism.

[dineshkulkarni]

I used BT 136 600E 1250.followed your instruction
some time it work nicely .

[andresinalbis]

using the triac the contacts of the ignition keys of lights, motors, etc are not damaged ... very good video

[jeffbowyer]

Excellent. Works with 220V from a wall socket and 40W bulb. Thanks.

[YGBMP-JZFLI]

Thank you for the idea, very useful for me

[Biswajit-ppgz]

you just gave 220volt ac at the gate of triac to trigger the triac
my question is how much time the 220 volt ac supply take the gate pin?

[nitinrastogi]

Thanks for explain of triac working. I want to know that what will be happen if gat connect with T1.

[mikesterling]

Will this circuit work for inductive load like ceiling fan ?

[SparrowVivek]

Could you explain the same with DC, the behavior is different

[rehan_the_gamer]

Good morning bhayya.
When we connect this triac to a ceiling fan, does it need heat sink.? Please reply.

[goutampraharaj]

Can we use this triac in vu units of heavy load like full chain light will glow with music?

[mrsemifixit]

How does the gate only handle few milliamps if you’re touching a 12amp line with it?

[sakraent.]

why need triac if we can direct light to source .. Is triac AC use only not applicable to DC..please..

[vishnukumawat]

यह हिंदुस्तान है यहां हिंदी बोली जाती है हिंदी बोलोगे तो ज्यादा लोगों से जुड़ गए और अंग्रेजी बोलोगे तो सीमित हो जाओगे

[bscgvrvr]

When there's no voltage at t2 how is it working with gate voltage

[vinaydhan]

Make your videos in hindi...it's good for your channel...groth.

[dhimassatriapratama]

Hi friend
How to add triac to led driver?

[lokeshkumaragarwal]

Which type of power supply and voltage you are using in this video

[zaidusman]

how much ac supply did you use in this video

[kaushikx]

be safe while experimenting with AC circuits

[gulsherahmad]

As you see, You are Connected the Gate Terminal Directly ( Without any Resistor ) with the T1 ( Terminal One ) which have Heigh Voltage ( 220, V ) . So Why the Gate Terminal Not Damage Due to you say, s Earlier that The Gate Terminal should be operated with 01..01.5-V . So what is the logic with them sir .