Timelapse of #PhotoVCarve with molding profile tool path around it

Adding a molding tool path around a PhotoVCarve. Set up info VCarve Pro was used in video
Bit used is #46771 Amana Tool 30° 0.005" V TIP (Any 30° 0.005 will do)
Max Carving Depth of cut is @ .058
Hatch
Dence 100 %
Line Angle @ 45°
Feed rate 90 in/min
Speed 45 in/min
Was cut using an XCarve clone

Finishing Tips
Remove ALL loose wood I use a wire brush and it works awesome
Put sealer on next
Now paint the carving with ACRYLIC PAINT (water based) After painting you will need some water in a boall and a rag. Soak the rag in water and wipe MOST of the paint off. If you're using the right paint, it will wipe right off easy as pie leaving only some in cracks and places that needs to stand out. After that do a VERY LIGHT sanding if needed (220 grit max) lower would be better. Last blow off the carving to get the dust out of all the cracks and seal it one last time ..... Good Luck

Vectric VCarve Pro software link

If you would like to support my youtube channel Please visit my Patreon page @

Thanks for Watching.

[Olivsam]

Nice what bit did you use for the profile?

[Dauney_widianto]

Dapatkah saya mendapat software gratis selamanya, sebab saya tidak punya uang.