Plumbing Rough In – Laundry Plumbing (EP6) - The Building Expert 2022

Plumbing Rough In – Laundry Plumbing (EP6) - The Building Expert 2022

In this video we are plumbing a three-piece laundry room. Very basic configuration with sink on the left side, washer in the middle and dryer on the right side. There two other vents coming from the basement which we connected with the laundry vent & penetrated one through the roof.

In this video we also talked about efficiency, common plumbing codes & interior design specs.

If you have any question, comment or suggestion for a video please comment below.
Subscribe to our channel and be the first to know about new uploads.
Enjoy!

#TheBuildingExpert #laundry #plumbing #building

Concept: Manvir Badyal
Youtube: @TheBuildingExpert

AFFILIATE Links to tools used in the video:

© Copyright 2022 The Building Expert (Manvir Badyal). All rights reserved.

DISCLAIMER: The Building Expert make videos to share the knowledge we have gained over the years related to construction. We are not responsible for any damage done to a property if someone decides to do their own plumbing by watching our videos. Always consult with a licensed builder/plumber before starting a project.

[TheBuildingExpert]

AFFILIATE Links to tools used in the video:

[laj]

You didn't remove burrs after cutting the PVC before applying adhesive???

[vboutique]

Do you have a video of tying plumbing for the sink & washing machine to the drains under the house?

[shiniyuxue]

I install laundry in basement where it has wet went drainline nearby, is it valid? 2nd, I want to install a kitchen sink as well. what is the minimum separation of those two wye fittings and what if the vertical pipe is at 45 degree angle ? thanks

[Semaj.]

Question my laundry is a French laundry it only has. A sink and how do I connect the washing machine to it ? No taps in the walls my plumber fkd up I think !
Can. Use divertor connect it under the sink to the main water pipe and t it to the washing machine ?

[justine]

Can I install a new utility sink drain pipe to the plumbing cleanout?

[eduardohernandez]

Maximum for a 2” is 5 feet dawg. And the trap has to be above floor atleast 6 inches

[kltnrjnnfr]

No plates to protect the pipe from drilling? Yikes

[fredchester]

Gluing ABS. I noticed that you're not following the correct manufacturer's procedure for connecting pipes; Cutting AND DEBURRING the ends, making sure the surfaces of the pipes to be joined are WIPED CLEAN of any dust/dirt, applying glue to BOTH SURFACES of the connecting pipes (and not just one), giving the glued pipe end a quarter turn AND HOLDING IT IN PLACE SECURELY for several seconds. The container from which you are getting the glue from APPEARS OLD AND DIRTY with lumped up glue (with sawdust mixed in) at the top. I'm assuming the glue may contain debris from the job or a past job, etc. Yes, you are working fast, but why introduce a problem(s) at this critical step of connecting and sealing ABS pipes?

[stargazer]

1 1/2 pipe for a wash machine and it has a laundry sink on it. Not good.. you need 2 inch pipe ..🤯

[ncooty]

Not a single cut deburred. Good grief.

[someguy]

Most codes (upc) requires a 2 inch trap to drain to a 3 inch stack or drain.

[TeslaBoy]

I a plumber in Chicago, Illinois, this plumbing work never passes a rough-in inspection here 🥵

1) abs not allowed
2) Every laundry needs a grey box.
3) wet vents are not allowed
4) Every laundry room requires a floor drain
5)vents separate for each discharge opening

[Scorpio]

Unuseful, you didn't mention any measurements and heigths