How To: ENVE Road Hub Service & Maintenance / Alloy & Carbon Hubs

Показать описание

Learn how to disassemble, service, maintain, and reassemble your Gen 2 ENVE Carbon or Alloy Road Hub. #iRideENVE #HowTo #HubService #SES

ENVE Composites

Рекомендации по теме

Комментарии

I have done this work on my enve alloy hubs. Tip on the snap ring. There is a ridge on the axle on the non drive side of the rear hub. There is space between the bearing and that ridge that needs to be taken up by the snap ring. Get that snap ring over that ridge. If you don't the result is that the end cap will not seat far enough onto the axle and there will be play in the hub. I stretched out the snap ring when I removed it and it was no good after that. I had to replace it. If you need to a new snap ring, I used an external circlip snap ring, size ∅18.

mellnhead

What sort of grease (if any) should be used on the ratchets?

imakeartwork

You only greased the bearings? I am here because when I took of finicky cassette, the freewheel came off with it much to my surprise. Im curious if i should grease it all up before reassembling

renaissancefam

any details about the bearing size? as well as the freehub bearings?

DennisPengawesome

It seems easy to remove end caps. I have Enve foundation hub and cannot remove them. Any ideas?

zenalarifin

I was literally looking for this video earlier today!

ankitkbd

Can you supply part number and dimension for the bearings?

Dimashoey

Can we get an update for this with innerdrive hub xdr

SabianDB

how often should the internal parts be replaced and greased?

Juan_More_Mile

I just purchased an xdr free hub body to replace Shimano on evnve set 3.4 with the new inner drive hub, but when I put it on and even hand tighten the end cap it is tight and doesn't want to spin well. can't find any info on what could be the issue unless the springs come out for the xdr hub body? anyone?

richardbrown

How do I remove the noise reduction bumper? Does the hub system need it, if not, by removing it will it make the freehub sound louder?

creative

Why is it so hard to remove the endcaps on my set of 3.4 AR disc wheels? I can't get to the freehub body. Do I squeeze the end caps and pull?

garyyip

I have the gen 2 carbon hub on a rim brake. It seems where the bearings sit, the carbon is striped and broken? Is it normal? Or does it mean my carbon shell is damaged? Is it because somebody hammered bearings into place or used the wrong torque / or over tightened the bearing tool?

malijawed

If I were to remove the axle on the front hub, thread it internally on both ends so that I could use bolts to secure it to my fork, would there be any reason that this would be inadvisable? I am attempting to use your carbon front hub for a track wheel set and you are not allowed to use a QR at the track. Thanks :)

caluzzucarrazzi