RUTX50 - Industrial 5G Router | Quick Start Guide

Need some help setting up your new Teltonika Networks RUTX50 Industrial 5G Router? Watch our quick start guide video and follow the step by step instructions to easily set up your new router for operation.



CONNECT WITH US:

[blleman]

I discovered this router while searching for a 5G wireless router. Been using it for a couple of days now, and it's way better than I could imagine. I've been doing networking with cisco etc. on expert level (CCIE) for more than 20 years now, and this one blows my socks off ! . The feature set is never seen, the usuability is fantastic, performance is great, and the RMS is a wonderful surprise. I've been using cradlepoint at my current consulting contract and to be honest they are miserable compared to this. You've won a fan !

[joacimlottkarr]

Will a dual Poynting LPDA-92 antenna work with the X50? There will be two mobile antenna connectors with no antenna connected in this case?

[bluestellae_]

For streaming, if the connection is cut in sim 1, does sim 2 automatically start working without loss of data packets or delay in the connection?

[maxastuto]

good morning, I am aware that this router has the "failover" function which is the function when a primary source ceases the connection (ethernet or sim 1) it automatically switches to the other (for example from ethernet to sim 1 or from sim1 to sim 2) . I am aware that it also has the "load balance" function, i.e. with multiple sources connected to the network (e.g. Ethernet, SIM 1 and SIM 2) and multiple connections (e.g. PC, tablet, home automation, video surveillance, etc.) with the load balance the bandwidth coming from the Ethernet is distributed for example to the tablet and video surveillance and that coming from the SIM card(s) instead between home automation and PC). I would like to know if it is equipped with the specific "multiwan" function, i.e. if you connect an Ethernet source to the WAN port at the same time, and 2 SIM cards with related ISPs, it is possible to have the connection from all 3 sources at the same time (or at least from 2 ) to have the total sum of speed and bandwidth on a single connected device (e.g. PC for heavy downloads). Thank you

[superiorstreaming]

I have just purchased.
Does the unit have any wifi range without the wifi antennas attached.
Generally I am set up fairly close to the modem.
My setup is mobile on a tripod so I want to eliminate extra cables.

[steveharris]

Have you got any instruction on how to us the router with an IP Phone such as a Yealink W76P ?

[wolffive]

Will this work with the US networks if so I would buy one and test it out over here

[azahsyafiahm.marzuki]

Where can i find information on the supported freq for the mobile antenna port, since you provide 4 ports, are they all the same?

[santoooo]

Default good configuration is missing.
I was need to learn about every option for find the best missing configuration..

[cut.mp]

Does this router support priority based communication, i.e when both 4G and ethernet are available I want the router to only get internet from ethernet and ignore the 4G sim and only during the failover we need the internet from the sim

[ausrider]

Can both SIMs work together concurrently in aggregate mode to basically double the bandwidth?

[tobydavy]

Is there a firmware update due soon? The device appears to be quite unstable requiring frequent forced reboots to get it up and running again.
Also, the signal reports -53db regardless of antenna positioning, is this accurate?

[stevenlilly]

What modem is in the RUTX50 and will it be available in North America?

[robert]

Why only have 3 bars of signal? come on!