Skinomi - Google Pixel 2 XL (Case Friendly) Screen Protector Installation Video

Screen Protector Installation Video for the Google Pixel 2 XL (Case Friendly)

**Written Instructions Below**

Preparation:

Make sure the device is turned off, and if possible, remove the battery before installation.

Wash your hands and wet your fingertips before handling any TechSkin™ pieces. This will help prevent fingerprints from forming on the film.

Clean the device with a lint-free cloth, removing any dirt, grime, or fingerprints.

Installation:

Spray a fine but even layer of solution on the adhesive side of the TechSkin™piece you wish to install. Keep in mind that you do not need very much solution during installation. A Fine but even layer is the key to a good, clean install.

Apply the TechSkin™ piece to the device with the adhesive side facing down. Begin with the larger pieces first, as they will act as a guide for small pieces. If a particular corner or small piece is not adhering to the device, let it dry for a few minutes before trying again.

Wrap a credit card or hard plastic card in the included microfiber cloth. and gently push the excess solution and bubbles away from the center toward the edges. Inspect the film after the squeegee process to make sure there are no bubbles – the protector should lay completely flat on the device surface. Micro-bubbles that appear while the protector is completely flush with the device will disappear after the curing process. If there are bubbles or the alignment is incorrect, gently peel the protector off and try again.

Perfection:

Please allow a few hours for the film to set and at least 4-5 hours before powering on your device.

You can use a hair dryer, on low-setting, to quicken the process and help the film set faster.

Micro-bubbles, streaks, and imperfections will disappear within 2-3 days.

[AndreaIppolitoIppo]

Just a heads up: avoid at all cost touching the adhesive part as shown in this video, follow the printed out instructions instead. I did that mistake and had my fingerprint on the adhesive part well visible on the screen at the end of the process. So I lifted the film again and sprayed some more solution and tried to make the fingerprint go away, which I succeeded to do. But now there are visible smudges on the adhesive side I'll have to live with. For the record, I had washed my hands accurately and I had sprayed a bit of the solution on my fingertips (both hands) before starting, but none of this helped preventing this from happening. Luckily there's a second film in the box, and when I'll apply that one, I'll make sure not to touch it on the adhesive side...

[lifeneedsmorechill]

Those nails are nasty! But quality product!

[aaron]

Probably should have watched this before trying to install it... woops.

[declanstark]

Those nails are like something out of whatever happened to baby jane

[pacmanlp]

Those nails were not necessary and gave me nightmares. Good product though

[netcalibur]

All this process with those nails? Give me a break. Disgusting

[ShinyRadHero]

Disliked the video because of the nails. Gross.