1986 Honda Spree - Sitting outside for 25 Years | Can we revive it? PT4

It's Finished!! Our 1986 Honda Spree finally comes to an end and we're thrilled with the result! Come hang out with us in the garage as we put the finishing touches on this little gem and unveil the finished product!!

E-mail us:

Our mailing address is:
Project Time Garage
1113 Murfreesboro Rd
Suite 106 #109
Franklin TN 37064

****Links to products I use, or are seen in the video****

DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you! Thank you for supporting this channel so I can continue to provide you with free content each week!

------Video Contents-----
0:00 Start
3:39 Honda Spree Clutch Install
5:30 Honda Spree Horn Install
6:39 Honda Spree Fairing Install
7:36 Honda Spree Oil Injection
12:31 Honda Spree Side Panel Install
13:52 Honda Spree Finished Product
14:58 Honda Spree Reveal to Owner

[davidrainey]

Incoming dad of the year award. Good job.

[trisic]

You did a great job on this! I have a 85 spree that I'm trying to get the headlight/instrumentation cover and the cowling right below it off so that I can repair and paint them. It is a struggle. Do you have any tips on this? I can't remove the black screws on the side because a nut of some kind must be turning inside.

[gabrielgalaxygh]

I just got 1 and cleaned the carb and now it starts up great and runs good but after like 3 minutes or once warmed up it dies and won't start. When I et it cool down u starts right back up again

[jaydonharper]

Hey man! Just ran across this video I just picked up a 1984 Honda Spree Nq50 it sat in a guys garage for 4 years and he couldn’t get it running. I’ve cleaned every nook and cranny in the carb, I’ve emptied out the gas tank and re filled it, we cleaned out the exhaust to the best of our ability, change the spark plug, air filter and we can get it on but it just bogs out after a few minutes then it takes forever to try and get started again. Any tips would help!

[juansuarez]

A couple questions. I opened mine up last week and it was full of oil everywhere. Crankcase. Piston. Spark plug. Drive belt. Muffler. You get the idea. Any ideas what might be causing that? Faulty oil pump? I didn't see you talk about the Reed valve in your videos. Did you mess with that piece at all? Also - I'm thinking about doing what you did and try running it with pre-mix first to get it to start. If I can pass that stage then I'll deal with the oil pump. Can you share what was your mix ratio between gas and oil? Thanks!

[Methavn]

You don`t need a license to drive a scooter in the us?

[patrickthenomad]

Subscribing for the promise of more spree content