Finish Strong Friday: Corridor Slope Benching Using Subassembly Composer

[Tracks]

Keep it up! Looking forward for more videos from you, don't stop!

[josethomasthiruvattal]

Thank Very much... for valuable informations.

[marcsamintog]

when i add link to point at the end of the loop, the link doesn't show. please explain why. thank you, sir

[labdra]

great, but it would be prettier if you had another IF where you check if terrain cuts through 2% bench. That way your bench would form properly at start and end of it

[Treed]

Alan,


I have a dumb question. I am trying to create a subassembly that basically targets two surfaces. I need it to project a slope @ -3:1 as far as possible from my design surface, then conclude at -0.25:1 to an offset parameter which is 2' off PL (basically to make a crib wall with as minimal a height as possible). I have tried composing with aux points but with no avail. I tried working from the bottom (EG) up, and from the top (FG) down. My work around has been project a grading object past the wall at -3:1 from FG, then us an assembly with a link to surface w/ slope assembly to FG surface from 2' off PL, see where it daylights, extract a feature line from the corridor, explode the dynamic line, convert back to feature line and Infill. Even that has been more challenging then I imagined. Any help on this matter would be amazing.

[amosyakubucruickshank]

i would like to see how create box drains with subassembly composer

[ariefRoblox]

Sir ! How to create diffrence slope eg: slope 1 = 1:0.8, slope 2=1:0.5 slope 3=1:1

[shihabpmf]

i cannot mirror this assembly, move and copy is possible, how can make left side

[nugrohosangaji]

how to make if parameter exsisting ground cuting bench position vertikal?

[sirmahmoud]

Hi,
Is it possible to make every link in the loop targeting the Target Surface according to EG surface changes just like daylight bench from civil 3d tool palette because the daylight passes through the EG surface at some areas?

[ramikhetan]

hello, please tell us why this subassembly don, t read cut and fill materials ?

[MrArshadmirza]

How to add a DRAIN to bench for rain water Pls help

[naseeryounasbhatti]

Sir how can add ditch before start bench Slope.?

[kimungkimung]

Error P5&L4 Failed to execute.. why?

[philipmadeley]

I have been looking for such a sub-assembly for some time. Is it possible to get a copy of this .pkt file?

[gcf]

Thanks where's the file joke haha

[richardwilmarsalascaballer]

Una consulta, como podría crear en subasemblies composer taludes variables para una transición?
Agradecería mucho su respuesta, saludos