Building A Magnetic Saw Guide Using Wood and Rare-Earth Magnets

Hello everyone！In this video i will show you how to make a magnetic saw guide using Wood and Rare-Earth Magnets.

[tflno]

I think this simple design is quite elegant.

[whomadethatsaltysoup]

Superb! Extremely simple and elegant jig for cutting straight, plumb 90s and 45s. Probably won't go down the 'scary router vs finger' dovetail route - lovely as the finished result is - but I'm keen to knock a couple of these bad boys up to get more use out of my Japanese saws. Thank you so much for sharing!

[VORONM]

Very good channel. High-quality, interesting content. I signed up. Good luck and prosperity!

[valterleao]

Excelente, excelente ideia, gostei muito e aprendendo, farei um, tomara que se aproxime ao seu na qualidade 👍❤️
Abraço aqui do Brasil 🇧🇷

[skitalec]

Удобная штука, вот только через пару десятков применений зубья пилы покромсают держатель. Нужна немного иная конструкцию, но я думаю, что позже автор и сам до этого догадается;)

[danjacobsen]

Those fingers are awfully close to that router bit

[robertkat]

These are neodymium magnets, Amazon has many sizes and shapes. Hold up to 500 pounds.

[nwood]

Почему у меня столько просмотров нету? Я че шутка какая-то?