Qidi Plus4 Beacon bed screws adjuster full mod

Hey gang 😁
so, after a lot of hours of designing and fiddling with these bed screws that are a pain in the bleep bleep to adjust ... i came up with this little mod.

***NOTE ... you can not use those on the machines that are still using the manufacturer's probe system since we need to get rid of the PIEZO brackets and there for would render the probing defective. ***

I am uploading and making the "How to install" so keep an eye on this for full release 😉🫡

Hope it will help out and make your adjustments a bit easier ... surely does for me 🤣🤩😁

Happy printing gang

LINKS:

[grottnlm]

Nice mod! The solution in Klipper looks really convenient. The locking mechanism of the nuts look like godsent! After i did the Beacon3D mod, i invested about an hour again to get the screws like 0, 03 mm from heighest to lowest. Thanks to the "integrated" macros from the model, i got it far better than ever before. The mechanism the machine was factory equipped with, is so freaking bad. I don't have words for that. Different tention on the locknuts made allmost more change in height than a full revolution of the knobs.
I've sworn to myself, that i will never touch them again.
If i have to, i will use your method.

[helixx_harpell]

So backlift is always off on these plus fours,

[montywhisp]

can you release on gihub please? the codes, description etc? this should be good to collaborate and improve this screwed bed level measurement

[emf]

Wonder how much it would cost to get them laser cut from send cut send or something

[myhttp]

when you upload the Mod, where are you going to place it?