Thule Omnistor Awning G2 Rafter Install SIMPLE

the simple Thule Omnistor Awning G2 Rafter Install to your camper van , caravan or RV , the thule omnistor awning is an excellent accessory to van life but the rafter comes with awful instructions on how to fit it to your van, its a simple process but hopefully, this tutorial makes it a little easier #shorts #thuleawning #vanlifehack

🔴 SUBSCRIBE FOR WEEKLY VIDEOS
🔴 MERCH
🔴 OFFICIAL WEBSITE
🔴 CHECK OUT MY AMAZON STORE
where you'll find all the van gear, upgrades, and all the stuff we use in the van
______________________________________________________________

you can sign up for free bellow
______________________________________________________________
______________________________________________________________

FOLLOW ME ON SOCIAL MEDIA

⚠️ Disclaimer: Some of these links are affiliate links where I'll earn a small commission if you make a purchase at no additional cost to you. Also as an Amazon Associate, I earn from qualifying purchases also at no extra cost to you.⚠️

[Fishd]

Fella, you're a life saver.

I love the way the official instructions say "Read the instructions carefully" ... but then there is just a couple of stupid pictograms.

[kevingallacher]

Absolutely loved this video. I have just spent 20 minutes trying to figure out the pictures on that useless piece of paper! Your video explained it perfectly. Thanks so much!

[A.S.K.]

Happily, mine came pre-installed on my motorhome. Almost identical to yours: (Thule Omnistor) BUT I had no idea what that "extra pole" was for as there were NO instructions... I did work it out later...🤔😂

Also on mine... when winding it out.. If you put the winder into the slot all the way...then rotate it a half turn anti-clockwise it locks into place. To get it back out after rewinding the awning, you need to push in and rotate half turn clockwise. THAT was a PITA as I didn't know ..and couldn't get the blasted thing out..
but, guess what..I DID have instructions.. but didn't know THAT, either... Found in a drawer. hahaha😅😁

[fionnut]

Great video, but 2 observations.
1. I think you have fixed the outer bracket incorrectly, the tip of if should go into the groove.
2. Once you install the rafter you need to wind back the awning until the collar on the rafter comes back in contact with the cap on the larger diameter section. This is what creates the tension and createst the strength. As shown you are only bracing against the spring tension in the rafter pole.

[Peter-at-Heres-The-Thing]

Very efficient editing, Neil. Good tutorial.

[michaeljohnson]

Hiya Neil and Emma i drove past when you were filming ha (Thursday teatime)

[HappyPlaceCamping]

Lol no instructions! Such a Did ‘Em approve of throwing those instructions away? 😂

[robincai]

Very good instruction, may I know where can I buy that plastic tab? What is it called?

[marieplacha]

the conclusion of the video is wrong, follow the instructions carefully, they are correct!!!