Rival Kronos PVC Speed Loader

Nerf Rival Kronos PVC Speed Loader. DIY.

I don't have a 3D printer and so this was what I thought of.

Supplies needed:
3 sizes of PVC, use a heat gun to get right sizes, etc. I just used what I had. Only the middle PVC piece was one inch edge to edge naturally.
Outer piece was made larger by the heat gun and sliding the center piece (uncut) into the main shaft spreading it and making it the right size and then cooling.
The center piece is much smaller pvc, not the right size, and just screwed in via the hook. Superglue is holding the stopper in on top.
Pretty straight forward, just cut to length by putting 5 rival balls next to each other. And then using educated guesses for PVC lengths etc.

[akziongarcia]

I made this for my x shot meteor and orbit

[blanket]

You are like the last person to do ths