Short: How to make the perfect jump ring

[ranielson]

✨Oxana✨ Thank you a million times over…. For sharing these absolutely wonderful idea’s! You are so kind! Greatly appreciated!

[sandmaker]

A great tip. I'll bet lots of folks do it the other way. Have fun! 😷⚒

[tammygurl]

I ❤ all your tutorials! This is absolutely great if you're making a minimal amount of jump rings. I bought some cutters that are "supposed" to cut flat on both sides but are difficult to use to cut multiples because they tilt when cutting. I also bought jump ring pliers to use with my saw and that was a waste of money. It was easier to cut them with my saw at my bench pin. Thanks for all the help you give everyone. Cheers!🙂

[PhoenixCreationsKaTyJs]

Wish companies would do that too lol loads I buy they are points one side and flush the other!! ❤❤😊😊

[jullesteach]

can you recommend cutters that make a flat cut

[nature-meow]

Thank you so much for this video. I cannot find anything about how to harden jump rings by hammering them. Can you suggest a site or a way to do this?

[janet]

I make a lot at one time
Their always flat, if there cut right.

[psychodrama]

Thank you!! I brought a jump ring tool, but I don’t know What size gauge is best.

[gstunna]

I love how detailed and perfectly explained your videos are.

[midnightbel]

What guage and firmness do you usually use for jump rings?

[keenapearce]

I bought a bunch of jump rings in all different colors went to make a chain and their all like the first one you said not to do 🤦🏽‍♀️

[apt.]

How do i know if i should get soft, full hard or half hard? I want to make small 3mm 22g jump rings.

[sherryhibbard]

Where do you get that tool to bend the Jump ring?

[chuckyDLuffy]

hello! i have a question what does hammering do? how does it make it stronger?