Replacing an Evaporator Coil on Trane 4WCY4030 Heat Pump

In this video I replace the evaporator coil on a Trane heat pump package unit. #hvac #hvacguy #hvaclife #hvactechnician #fieldpiece #acrepair #hvacinstall #milwaukeetools #trane

Here are links to the tools I use, And it costs you nothing extra to buy from this list:

[Silky_boi]

When your recovery machine finishes, your supposed to turn the dial to self purge and it’ll recover the remaining refrigerant in the recovery machine. 👍🏻👍🏻👍🏻

[phillipjoy]

A rosebud tip works great for un sweating those coils.great videos 😊

[GlenS]

Another nice video. Never had any luck with that style nitrogen regulator. Always used a bubble regulator, adjust it so the B B in glass would just barely float. Always gave perfect tiny flow, also saved nitrogen.

[dustinturpin]

I changed a txv out on one just like that a while back. I pulled the blower assembly and crawled in the unit to get to the back side lol. Love watching your videos. North Georgia boy here.

[daviddesilva]

At 2 minutes code says you have to use the whole roll of tape on a low voltage splice. Thxs for the vids!

[tphvac]

It’s hard to stop a Trane 😂 nice work Curtis!

[ericcrenshaw]

I did this same coil replacement about a month ago. Took the blower out to get to the back of those lines since my mirror went missing. You make it all look so easy.

[josephzarate]

I’ve done a few of those coils to make it a little easier I found using a large ratchet clamp to lift up the top part of the unit and will give you more space to braze the suction line in but great stuff love watching all you vids and channel 🤙

[donnyjackson]

Your a brave man recovering all the refrigerant without looking at the new coil first to make sure it’s the correct one first! Great content as always!

[ant]

Oh my I keep you talking about rain, we need it here so bad in California, Love your videos.

[gingyberrie]

thanks for the vidoe.. when unsoldering coils i always cut the pipe below (towards the coil) then pull the old coil out then sweat off the copper .. much easier with plenty of room after the old coil is removed and you don’t have to fight pulling a pipe straight down

[mnhvacguy]

New subscriber. I like those kind of jobs too, I get into a zone and forget about all of my problems for awhile. And the satisfaction when you turn the power back on and everything works and the customer is happy with the repair. I love that

[MariosACandRefrigeration]

You were lucky not to melt the solder on that txv bulb, great job thanks for sharing.

[lindaSee]

Why do I like watching guy stuff but I do.
My late dad taught HAVC in night school. He learned it in the Navy.

[jaymz]

Been following you for a few weeks. Definitely my new favorite HVAC dude to watch.

[jacobreed]

Good job on that. We are a Trane dealer at the company I work at and we do quite a bit of these coils. I always found it easier to take all the screws from the condenser top and take a 2x4 and prop the top up.

[keithsac]

You might want to get you a captain hook tip for brazing tight spots like that. Makes it so much easier and you wouldn't have burned the insulation.

[Paulie]

I wish you would wrap your TXV when brazing

[jamesfitzsimmons]

Good job Curtis. I felt for you buddy during your brazing. You sure get a lot of challenging work

[donaldpainter]

I've done hundreds of these over the years