Mahoe Minimax Quick Tutorial - Milling Huge Pine Beams

Hey Everyone! Huge thanks to everyone who has supported my channel so far and for helping to reach 1600 Subscribers! Just made a video to explain a little bit of how to use the Mahoe Minimax. We are also staring a timber frame car port, which is what this lumber we are milling is for. Hope you enjoy!

[bendugas]

Thank you, I was actually counting the turns as you went to a 12-inch dept cut, now this video is to my favorite and watch later, I'm going to wear it out.

[JoelAllen-xjcg]

I like how that saw goes&brings back a board-seems efficient compared to bandsaw/edger setup-who is bald head guy?

[bogus_not_me]

What are the largest cuts you can make? I'm sure it's just less than half the diameter of the blades, but I don't know that either.

[delprice]

Does one need to check blade overheating on deep cuts? Fantastic video!

[TheRussellStover]

Do you do anything with the sawdust? Like make wood pellets for stoves?

[bendugas]

This mill, what is the longest piece you can saw in it?

[bwillan]

Seems rather odd that the horizontal sizing dial couldn't be made larger so it wouldn't have to go around twice to get your 8" or 10" desired cut. I get that you usually only cutting 2 to 4 inches thick at a time. What is the kerf of the saw blades? It looks huge when you see the offset amount on the sizing dial.

[Pfs]

Olá bom dia! Da pra levar essa máquina para o floresta e monta

[patrickhart]

What do you do if you need repairs? Will NZ Mahoe take your call and give support, sent parts?

[Histandard]

Looks like you. have the easy part of the job while your wife is busting her butt (I have run a mill for years and know there is no easy part.