Rugged Ridge Snorkel for Jeep JK

Follow me on IG:

My favorite Jeep JK phone mount in the link below. Look for Pack #6 in the 'Mount Pack' section:

Recon video of the Rugged Ridge Snorkel. I spotted this Jeep JK and stopped to document the kit for anyone that had interest in picking one up for their Jeep. It basically serves to give you a little bit more insight into the snorkel kit.

Share this video:

Disclaimer:
I cannot guarantee against improper use or unauthorized modifications of this information. Jeeparmy USA assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Due to factors beyond the control of Jeeparmy USA, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Jeeparmy USA. This video is solely for entertainment purposes only.

[TrailRecon]

That's a great looking snorkel set up, very clean. Thanks for the video.

[MonsterJeep]

Am I mistaken, or is that quite the body lift on that jeep? or is it that the inner fender liner is missing?

[simisonicblack]

I have this same snorkel bro. I love it. One of the things i love most about it, is that it doesn't get in the way of the door when trying ti take it off or put it on. Also it has a drainage valve on the bottom that you can open if driving through rain.

[the_bombdigiti]

I doubt you'd have the answer for this but does this snorkel work with the Smittybilt XRC Armor Fender Kit?

[jeepnfr]

This is the snorkel kit that came with my 2016 Jeep Wrangler Sport which I just purchased from the dealership.
Today I noticed that the eye holes in the air intake hose do not line up and the bolts are missing.
I'm trying to find out if this is because of the snorkel modification or is this something I should have looked at and fixed.
Everything seems to be in there tight though.

[wsigona]

K&N has one now like this kit. No hood cutting, but you would still need to cut some of the inner fender.

[Losman]

I have an aftermarket cold air intake (it's the banks ram intake) will this still work and fit for the intake box?

[NeBoFoRiOn]

good vid not good location for pipe with no inner fender i cut my fenders but left some inner fender not shore if it will cover the pipe but now i can check great stuff man thanks

[santiagonunez]

Anyone have a similar intake? If so what is the intake air temperature compared to ambient temperature

[flopipr]

It has broken the plastic and not even it is used in the mud only has received water of rain and sun The plastic is of poor quality