Baxi Connected self-help: how to repressurise your boiler

This video explains how to repressurise your boiler. First we show you how to identify whether you have an Easy-fill filling link, a Rigid filling link or Flexi filling loop. Then we explain how to repressurise your boiler using whichever filling link you have.

[papakwadwo]

You are spot on. I followed your instructions and I got my boiler back working again, many thanks.

[PaulWrightIV]

Brilliant, thank you. Stayed at an AirBnB where the boiler needed re- pressurising and this was invaluable help

[MagsPM]

Thank you for this video. It really helped as I was at a complete loss and very stressed out.

[TheRHYSD]

What about when you pull the lever and nothing happens?

[shizokagaming]

Great video, proper informative, just be aware that sometimes the fitting loop may not line up properly based on snagging issues from the installation, what ever you do, DONT CROSS THREAD!

[heffo]

Thank you for the video. Very simple and easy to follow.
Mine is the flexi filling loop. We have had no problems with pressure until today (Low Pressure). The plumber showed me how to adjust it but it's been 8 months so I'd forgotten that there are 2 valves to turn. That one of the valves was hidden behind some towels didn't help me remember. 😂

[RHTHM]

Top notch. I knew it was something to do with the two valves, but one of them was a bit stiff and I didn't want to break the fitting.

[vimr]

"Don't worry if its a bit stift" - the best piece of advice I got from all the videos I watched on the subject !😊

[neilburton]

Really helpful and easy to follow guide. Thank you.

[ezeyisc]

Thank you so much for this easy to follow video

[Andy-jfpq]

Thank you .. saved me a plumber call out cost!

[teslime]

Thank you for the video. Our boiler is rigid filling link type . The copper bend was attached already and not have the cups. Do we need to remove the copper bend after pressure is ok? Without cap how we could remove it?

[ceylonuk]

thank for the video 🌺🌺❤

[gillitte]

Thank you for this video. I was so stressed out. Thankfully I thought of u tube.

[williamnepe]

Thanks so much, didn't realise it would be such an easy fix. Cheers!

[Ron_Gifty]

Thanks very much for this video . Helped me a lot ❤

[premserwan-xxcp]

Thankyou for this video.Verry informative and so easy to follow.I am shure it's helped many many people.🙂

[VamLoveAndKisses]

Very helpful, I have a a rigid fitting loop with the connector pipe already fitted. Very simple and easy.

[marciadurrant-aris]

What is the solution if you over pressurize by going into the red area. Hot water continues to run through the pipes non-stop. The Pressure Gauge get very hot and fogs up.

[Dw-vbfm]

Wheres the pressure release valve i need my pressure bk down