RIVNUT tools- $2 diy vs $73 hand tool vs $189 pneumatic gun

Short video to break down different tools I’ve used over the years for Rivnuts.

Hope this helps.

Pneumatic rivnut tool

Astro hand rivnut tool

[GlueTubber]

I've been a rivnut fan for a while - that pneumatic gun is schweeet!

[gnospam]

I recently purchased the style that runs as a drill attachment. The beauty of the hand one you showed and the drill attachment one is they only pull on the mandrel. They do not rely on low/inconsistent friction of the threads as they pull by turning the "bolt" mandrel much like your DIY method does. I have also used the DIY method; however, I did not use a washer I just took the side of the nut facing the rivnut and roughened it with very course sand paper.

[sherrymoore]

Your videos are always so helpful!!! Perfect video to share to explain what RivNuts are to people who have never heard of them!!

[dudeaciousmonstrosity]

The DIY method at 2:18 did not end with a good front side seal because the sheet metal was too thin and waving a lot. Against a thicker metal, the result will be better for the DIY method.

[TrailBoundco]

do you use it for plus nuts? why the riv nuts instead of plus nuts?

[TBJKJeep]

They make a different style of the lever operated version. Our Makerspace has one that loads just by opening the levers, it spins the threaded portion making it quicker to get a rivet nut on. Also I used a couple other ways as well too. A power steering pump puller has a bearing setup that works well. Another way was 2 pieces of plate & used 3 bolts. 2 of the bolts threaded into the plate & the 3rd into the rivet nut. Tighten the 2 bolts & it would expand the rivet nut. I made this version before finding the power steering trick. This was in probably 2008.

[joshhimelblau]

That was an awesome video. Made it so simple!!

[marineyacht]

How many psi you set your air compressor ?

[nickadams]

Would you recommend a second pass with the tool to ensure a tight crimp? Or would that likely cause issues?

[michaelcouey]

That pneumatic sure looks like a much better solution than the big bolt-cutter looking tool like I have. I just hate dragging around air hoses. Is anyone making a battery version?

[jakeedgington]

Do you know if the gun would work with the mollys that come with adrian steel products?

[koruoverland]

Can you attach these to the outside skin of the van?

[alaskalogcabinyoga]

we have the same gun- have you tried it with plus nuts?

[dthomas]

Thank you very much for this video
I want to get a pneumatic gun with mandrel to fit existing holes in my Sprinter van
When I measured the holes it looked as though they were close to 8mm which seemed to be about an M5 but most gun included the one you referred to are either down to 1/4 or M6
Which size are you using?
Thanks

[Therealdylanferreira]

Awesome, just learnt somthing thanks!

[fishwhisperer]

Really like the pneumatic but you only get 3 sizes with it, then you have to by a whole kit to get other sizes? Can you order just the mandrels from someone?

[merlyntownley]

What is the pneumatic riv nut gun that you're using? And you know some close-ups would be awesome. Just saying.

[EcoGreensFarm]

LOL. That is my shop now! haha Where did you guys move? Still in scappoose?

[bobcristianjn]

Cool video man, I'm from Brazil, I use a tool similar to your pneumatics. I have a question, is the tip screw not the problem? Does the thread not break? my problem here is this.

[paulfarrow]

Can you send link for air 0peratored please