DIY NARROWING A FORD 9 INCH

In this video we use basic hand tools to narrow a ford 9" at home this same process can be repeated very easily in your own garage

[IronheadGarage]

Nice job! Great idea on the fill spout the fatory should make them that way much easier to fill. Nice to have a drain as well. Need to build myself a rearend one day been looking for a old late 50s pontiac for my 55 getting hard to find these days. Thanks for sharing
Take care👍

[marcustyus]

What did you do about the axles? They have to be shortened also, correct? The video was very helpful just didn't see what you did to the axles.

[isaacgreen]

Hey, how you doing, buddy I'm trying to do that to my rear end. But I'm not shorting it Just trying to put different brackets on it like your doin To fit my emergency break.Bracket That goes over my roaders Do I need to take out the whole carrier

[timtrisler]

what's the part number for the housing ends?

[davidcook]

I didn’t notice did you use change the axles ? Great vid ! Well done !

[johnrushing]

Thanks wondered how to narrow one. Are you use flux core or gas welder?

[davidmatousek]

Put those end weld on pieces in the oven at 350 for 30 minutes then they will drop on

[DonTharp]

Dude ypu cannot level off level, ypu level off whatever the item is setting on!
If the floor isn't level what wth makes you think the item is level when you just put a level on it?
Wow!

[juanitokikiki]

i guess dares diffrent ways to skin a a$$