HyperCube Evolution #2 - Parts and Frame

Video #2 Parts and Frame - HyperCube Evolution CoreXY 3D Printer by Scott_3D

[NovaRealmXs]

I was on way already assembling the hypercube from tech2c but, this is definitely the way to go!! I was going dual Z with 12mm rods and I see this build fits my needs very much. Thank You!!

[zarro_boogs_found]

Hi Scott, nice job! Have you given any thought to using 4 z-axis lead screws (one on each corner of the build plate) each with a timing pully and ganged with a large timing belt loop around all 4 pulleys, then drive all of them with a single, beefier NEMA motor? I'm thinking it may be a bit cheaper than using the linear slide rods and dual-z stepper motors.

[vaughanza]

Thanks Scott for another great video and for sharing the files. Appreciate it. You star

[ThinkOutsideMind]

How to programmed the ramps and calibration the printer please

[solidus]

really nice job designing the parts mate ive been considering converting mine to dual z axis since i built it works grand as is but I always thought it would be more stable to have it supported both sides

[willditto]

Awesome build and design.. Any consideration regarding 0.9 degree steppers and one of the 32bit controllers?

[DrejerDK]

Have you considered using carbon fiber tubes instead of the linear rails? :)

[msdesignru]

Pretty good review. Thank you. We are gonna build our own printer soon too.

[bentlikeitsmaker]

igus also has a drop in replacement for the lm8 uu bearings

[LemarinelNet]

What do you think of using M8 "standard" lead screw instead of those you seems to have used ? Will they be OK ? They are wayyy cheaper than "printer lead screws" ??
And if I'm going the dual Z version, what about 8mm steel rods instead of 12mm ? I think that with dual Z, the mechanicals constraints won't be so high ?

[kaliboeshoots]

what filament did you use for the 3d printed parts. can you also share your slice settings. I am new with 3d printing.

[Robbrown]

Would be good to see a carriage with the facility to add a BLtouch?

[jarmstrong]

a friend of mine told mw about this build, I have a net a8 plus am I abel to use the most parts from that to build this?

[EnnTomi]

is there a list for fasteners? the BOM list only have big parts. i want to know what M6 screw he uses and the brass insert dimension

[amkh]

how long are those 30*30 and 20*20 extrusion for 30*30*30 print platform ?

[dougcronkhite]

AliExpress doesn't appear to have the heated bed you mentioned anymore

[Robbrown]

Hi I tried to follow this however I can’t see how you fit the four 420mm in between the others it just doesn’t fit if the internal is 410

[FreelanceDAnimation]

Hi Scott. In this video you mention M6 screws but the BOM on Thingiverse only has M5 and M3. Please advise.

[Crits-Crafts]

any advantage of the optical endstops over micro switches? I know micro switches wear out eventually, but are a hell of a lot cheaper too

[jimmydrinks]

Hi Scott, could you maybe let us know which RAMPS board you're using with the due?