Replacing peugeot expert & dispatch door handle mk2

Avoid the extortionate manufacture prices & do it yourself for as little as £10, tutorial video demonstrating how.

[roberthopkins]

Well done Scotty... Fixed my van and still got half my lunch break left...

[stevebatt]

Thanks so much for this, I was nearly away to a mechanic to have this done so you've saved me a few quid! Cheers mate!

[Marc.Vanguard]

Mate, thank you for this. Perfectly explained sorted mine now.

A proper how too video.

[jamiejensen]

Spot on, thanks. I managed to get the lil hex hole turning by ramming a flat nosed screwdriver into it, as my torx and my hex drivers were too far for the hole. Took quite a few turns but the block popped out in the end. Installation was the reverse of exstallation!

[altowers]

Great tutorial also works for Berlingo van back door!👍

[MrHvfan]

Thanks very much for this. Really appreciated the time you saved me. All the best

[aydinozdolek]

Thanks for the video mate, saved me a hundred quid. Proper quick to the point as well

[johnrobertson]

Thanks for all the nice comments guys this was just a job I did on my sons own van

[deecarter]

Very useful. I've got a Fiat Scudo (same as the Expert) and the little trim bit is loose. Now I know how to tighten it.

[jw]

Thanks buddy - I was about to drill the rivets from the interior handle.

[MrToymod]

Many thanks, still crap you have to drill off the rivets on the other side if the cable breaks, that Peugeot for you!

[ubaldocorda]

Hi and thanks for the tutorial, I managed to do it in under 30mins. I have a bigger problem, rear barn door, d/side whole lock mechanism replacement...please, please.

[philocn]

do you have a video of replacing the rear door barrel? mine has fell loose and all came off includingh the handle. im guessing the rertaining clip has com off?

[glencoe]

There are some differences between handles. The 08 and 14 expert/dispatch/scudo are slightly different and not inter changeable. Firtsly it is torx 20 screwdriver you need and you need to turn a good few times before the small section of the handle comes loose. Secondly the 014 model has a different profile from an 08 and this is possibly where Andrew Morell below is struggling. The 08 has a slightly chunkier front section and it is difficult to get it to slide in, as shown on the video.

[geordiesimon]

Hi what size is the hex head bit I need i cannit see in2 the hole 2 see the size thanks

[andrewmorelli]

I’ve just changed the lock itself, and cannot get the cable hooked to the inside of this handle. I’d love to know how to do it please. I’ve got the cable attached to the inside handle, and that works, but I’m stumped on the outer handle

[atifmalik]

Hi mate, I have Peugeot e7 taxi, left customer door is not closing, common fault, can you recommend any garage or how I can fix this? I’m based on Edinburgh.

Much appreciated mate 👍🏽

[GB-ypff]

Thanks for the video, how many mm is the hex on the screw head?

[TT-rxhm]

Wonder if it's the same on a citroen c4 coupe 2008