How to varnish a door. Varnishing a door.

How to varnish a door. Varnishing a door. Steven from inexteriors is showing how to varnish a door using Ronseal diamond-hard satin, water-based varnish.

Tools to help make decorating achievable.

Ronseal Interior Varnish Clear Satin 750ml.

ProDec 4 Inch Dusting Brush Soft Bristle Brush.

Purdy 144380520 Paint Brush, Brown, 2in.

Hamilton 23140-005 Prestige Pure Synthetic 5 Paint Brush Set.

Prodec Craftsman Green Aluminium Oxide Rolls 80 Grit.

Faithfull 120G Aluminium Oxide Paper Roll 115 mm x 5 m.

180 Grit SandBlaster Sandpaper Roll Fine Between Coats.

Draper 53088 Plastic Paint Kettle, 2.5L.

and affiliated sites.

[oluseyisoledolu]

The processes were clearly explained. Now l can vanish my doors.

[nicted]

Thanks very much for your instruction most helpful as I have six doors to varnish.

[real]

Very helpful guide. Good to see you can varnish them while they're still hung. Does varnishing the bottom edge require taking them off their hinges though? Shame I didn't see your video before I bought the varnish though, as I initially bought the Ronseal satin light oak, which gives the wood a green tint!

[MsJessicaSugarplum]

This is very helpful thank you. Would you say a brush or roller would leave the smoothest finish?

[radu]

How long do I need to wait after the first coat was applied before starting on the second?

[philbertramsey]

Great vid mate! I have 13 of the very same doors to do. Quick question why do the edges first?

[giedriusmatulaitis]

You dont see connectiom when you varnish half doors and then others half, is it not darker in the middle? And is it not better to do from top to bottom each piece?

[chrismc]

Doesn't the door need oil based varnish. That's what the instructions said on the door from doorstore. It takes 16 hrs to dry.

[anitachin]

Can you use the same technique for an exterior front door

[jeetinderthiara]

Great video, I have the exact same doors fitted recently; most of them were 'pre-finished' when purchased from Wickes but there were 2 which were 'unfinished'. I'm trying to varnish the unfinished ones so they're the same colour as the pre-finished ones however not sure if I need the Clear Ronseal varnish or possibly a Light or Medium finish. Any ideas?