Kubota Bx25 Rear PTO bearing replacement

A technique used to reassemble 2009 BX25 tractor that allows the PTO shaft to slide in to the transmission so that the rear PTO cover can be reattached. If you take on this project you more than likely will have this issue when you are putting everything back together. Thanks for watching.

#kubotabx25

[dougsholly]

This is a bit old, but my PTO cover on my BX1880 developed a leak, and I couldn't for the life of me figure out how to get that shaft back in. Thanks so much for posting this!

[oliverorange]

Just to update...I finished my cover....I never would have gotten in back together without your video of raising the shaft end...Thanks

[jeffkist]

Thank you this video saved the year !!

[Gurusi]

Not a lot of info on the forums. This was a lifesaver during the job.

[timothybrinton]

Been going nuts trying to get that shaft back into position.
Same setup on box 23s.
I’ll try you’re technique tomorrow. I ran out of daylight

[jeffpeterson]

Could you share the process of putting the cover back on and what the seal is? Mine is leaking and can’t find anything about what to use/buy.

[randellrose]

Is there a certain way the splines have to line up? I cracked my cover and thought it would be a easy fix until it came to getting this bearing shaft to go back in.

[rendyck]

Did you completely remove the shaft that you show being realigned? I've broken the gear that engages the PTO stub. Thanks for the video!

[valdagirgensons]

Good tip! but how did you get the cover back on?

[oliverorange]

Having trouble removing rear cover at the spot where thee bearing you replaced sits....any ideas?

[marybeth]

does that shaft come all the way out ?