Sixth Sense Device Assembly

1. Push motor gently into center pocket of palm mount.
2. Slide IR sensor into place over motor- slide under the large nub, pivot to snap into place
3. Push 5V regulator in to clip. (?)
4. Push op-amp into 8-pin socket. The pocketed sides should line up.
5. Push three-wire connector into IR sensor clip.
6. Push 1 velcro strap through each of the 2 edge slots, looping through the self-contained slot. Both should be velcro side up.
7. Wrap excess wires and circuitry around IR sensor. Line up battery clip wire with either velcro strip. Push palm mount cover on to palm mount.
8. Place end of one velcro strap through slot in the other, such that it can attach to the second strip. Run long strip through slots of the battery mount, and fasten end through start slot to fasten.
9. Slide battery into place under strap. Push down battery clip to power on.
10. Unclip one side of the battery and swivel battery clip to break connection to preserve battery.

[sathyaramesh]

@silas i am also i secong yr with no knowledge of programming